Omron NT600S Manual - Northern Industrial

Connection to a PC by the Host Link Section 2-4Units with Built-in Host Link Function CPU Units Connectable Using anPC Series Connectable toHost Link Unit CPU Unit Expansion Communication BoardCV series(*)CVM1 series(*)CV500-LK201 CV500-CPU01-EV1 CV500CautionCV500-LK201 CV1000-CPU01-EV1 CV1000CV500-LK201 CV2000-CPU01-EV1 CV2000CVM1-CPU01-EV1CV500-LK201CVM1-CPU11-EV1CVM1-CPU11-EV2CVM1CVM1-CPU21-EV1* : Connection is not possible to the CPU units of CVM1/CV series PCs that do not have the suffix “-EVj”.In the case of these CPU units, make the connection to NT600S by using a host link unit.2-4-2 Connecting the NT600SConnecting to a PC with a 25-pin ConnectorRefer to the illustrations below to select the appropriate cable for the unit connectorsand connect the NT600S to the PC.To make a connector cable, refer to Appendix E Method for Making the Cable forConnection to the PC/Host (page 265).S After connecting a communication cable, always secure it with the screws.Otherwise the cable may disconnect, causing operation to fail.S The cable’s tensile load is 30 N. Do not subject it to loads greater than this.Otherwise a discontinuity may occur, causing operation to fail.Use a connector cable with a 25-pin connector on one end and a 9-pin connectoron the other end (NT600S side) to connect the NT600S to a PC with a 25-pin connector.NT600SHost link unit/CPU unit9-pin connectorHost I/F connector(RS-232C 9-pin type)SYSMAC C seriesPC, CVM1/CVseries PC25-pin connectorRS-232C connector cableUse the following recommended cables (OMRON);ConnectorSpecification25-pin to 9-pinTypeXW2Z-200SXW2Z-500S2m5mCable LengthApplicableHost Link UnitC500-LK203C500-LK201-V1C120-LK201-V1C200H-LK201CV500-LK20132ηττπ://νιχοντρολσ.χοm