t230 grass trimmer t230x grass trimmer c230 ... - Shindaiwa USA

AssemblyCutting Attachment Shield All ModelsSocket-HeadCap ScrewT230BoltT230X/C230BracketOuterTubeCuttingAttachmentShieldUpper ClampClamp ScrewShimNutsShimLine CutterShimRetainingNutFigure 14CuttingAttachment ShieldMounting PlateShimFigure 14AHex26013ScrewsNutCutting Attachment ShieldInstall the Cutting AttachmentShield T230/T230X/C230.1. Insert the cutting attachment shieldbetween the outer tube and the cuttingattachment shield mounting plate.See Figure 14.NOTE:It may be necessary to loosen the retainingnut and clamp screw to adjust cutting attachmentshield mounting plate.2. Fit the two shims and the bracket overthe outer tube and loosely install thefour socket-head cap screws. SeeFigure 14.3. Tighten the four socket-head cap screwsto secure the cutting attachment shield.CAUTION!Make sure the clamp screw and retainingnut are securely tightened before tighteningthe four socket-head cap screws.WARNING!NEVER operate the unit without thecutting attachment shield installedand tightly secured!Sub-Shield T230X and C230.(when trimmer head is in use)1. Attach the shield extension to thecutting attachment shield.WARNING!NEVER use this machine without subshieldwhen using a trimmer head.Sub-shieldFigure 15CAUTION!Cutting Attachment ShieldHookReceiverMake sure the sub-guard iscompletely hooked at the hookreceiver.HookTo Change Position ofLine Cutter.The line cutter can be positioned in2 positions to obtain different line lengthfor cutting.1. Remove the 2 hex screws with a 4 mmhex wrench. See Figure 14A.2. Rotate line cutter. See Figure 14A.3. Reinstall the two hex screws and tightenthem securely.WARNING!The line cutter is very sharp. Weargloves to protect your hands whenhandling.NOTE:Be careful to not lose the 2 nuts in the cuttingattachment shield, they are not captured.