ATR243 User Manual - Northern Industrial

293031Alarm 1 DelayAlarm 1SetpointProtectionAlarm 2Alarm 1 delayAlarm 1 set protection.Does not allow user tomodify setpointAlarm 2 selection.Alarm intervention isassociated with AL2-180…+180 SecondsNegative: delay in alarm outputphase.Positive: delay in alarm entry phase.Default: 0.Default(Disabled) Default(Absolute Alarm)(Band Alarm)(High Deviation Alarm)(Low Deviation Alarm)(Absolute Command setpoint Alarm)(Start Alarm)(Cooling)32Alarm 2 StateOutputAlarm 2 output contactand intervention type(Loop Break Alarm)(n.o. start) DefaultNormally open, active at start(n.c. start)Normally closed, active at start(n.o. threshold)Normally open, active on reachingalarm 5(n.c. threshold)Normally closed, active on reachingalarm 5∗ The display of the decimal point depends on the setting of parameterand parameter .5 On activation, the output is inhibited if the controller is in alarm mode. It activatesonly if alarm condition reappears after that it was restored.36ηττπ://νιχοντρολσ.χοm