ATR243 User Manual - Northern Industrial

More documents

Recommendations

Info

13 Table of Anomaly SignalsIn case of malfunctioning of the system, the controller switches off theregulation output and displays the type of anomaly.For example the controller will signal the breakage of any connectedthermocouple by displayingnotifications, see the table below.# Cause What to doE-01 Error in E ² PROM cellprogrammingE-02 Cold junction sensor fault or roomtemperature outside of allowedlimits.E-04 Incorrect configuration data.Possible loss of calibration values.E-05 Thermocouple open ortemperature outside of limits.(flashing) on display. For otherCall AssistanceCall AssistanceCheck if the configuration parametersare correct.Check the connection with thesensors and their integrity.ηττπ://νιχοντρολσ.χοm49
14 Summary of Configuration parametersDate:Installer:Notes:Model <strong>ATR243</strong>:System:Command output type selectionAnalog input configurationNumber of decimal pointsLower limit setpointUpper limit setpointLower limit range An1 only for linearUpper limit range An1 only for linearAutomatic setting of linear input limits.Offset calibrationGain calibrationRegulation typeCommand output reset typeContact state for command output in case of errorDefine the OUT1 led stateHysteresis in ON/OFF or dead band in P.I.D.Command delayCommand setpoint protectionProportional bandIntegral timeDerivative timeCycle timeLimit of output power %Alarm 1 selectionAlarm 1 output contact and intervention typeReset type of alarm 1 contact.State of contact for alarm 1 outputState of OUT2 led50ηττπ://νιχοντρολσ.χοm
Page 2: Northern IndustrialReliable spares
Page 15 and 16: 6.3 Keys8 • Allows to increase th
Page 17 and 18: 7.5 Soft StartTo reach the setpoint
Page 19 and 20: 7.8 Memory CardParameters and setpo
Page 21 and 22: For the calibration procedure refer
Page 23 and 24: 8.2 Digital Input FunctionsDigital
Page 25 and 26: The following figure shows an examp
Page 27 and 28: Modbus RTU protocol featuresBaud-ra
Page 29 and 30: 1016 Start/Stop0=controller in STOP
Page 31 and 32: 10 Configuration10.1 Modify Configu
Page 33 and 34: ATR243-31ABCCOMMAND ALARM 1 ALARM 2
Page 35 and 36: 13141516171819202122CommandState Er
Page 37 and 38: 293031Alarm 1 DelayAlarm 1SetpointP
Page 39 and 40: 40Alarm 3 StateOutputAlarm 3 output
Page 41 and 42: 55ConversionFrequencyFrequency of s
Page 43 and 44: 62636465GradientMaintenanceTimeUser
Page 45 and 46: 12 Alarm Intervention ModesAbsolute
Page 47 and 48: Band Alarm ( selection)PvComand Spv
Page 49: Lower Deviation Alarm ( selection)P
Page 53 and 54: Digital input functioningGradient f
Page 55 and 56: 54ηττπ://νιχοντρολσ.
Page 57: PIXSYSVia Tagliamento, 1830030 Mell

ATR243 User Manual - Northern Industrial

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?