EXPLOITING EMBEDDED SYSTEMS THE SEQUEL!

More documents

Recommendations

Info

The Serial InterfaceMAX3232 SchematicCopyright © 2007 Juniper Networks, Inc. Proprietary and Confidential www.juniper.net 12
Locating the JTAG pointsTypical scenarios:• Full JTAG header in place• JTAG points but no header• No JTAG points (solder directly to chip)Voltmeter must be used to trace connections.Use pin-out from vendor (if available).Copyright © 2007 Juniper Networks, Inc. Proprietary and Confidential www.juniper.net 13
Page 1 and 2: EXPLOITING EMBEDDEDSYSTEMSTHE SEQUE
Page 3 and 4: Embedded Architectures• MIPS and
Page 5 and 6: The ARM Architecture• RISC based
Page 7 and 8: The BDI2000JTAG Support for:• MIP
Page 9 and 10: The JTAG Interface - ARM/XSCALE•
Page 11: The Serial Interface• Support for
Page 15 and 16: Connecting the BDI2000Copyright ©
Page 17 and 18: Defeating the Watchdog• Software
Page 19 and 20: Debugging and Reversing• Flash on
Page 21 and 22: Debugging and Reversing• Decrypte
Page 23 and 24: New Attack Classes• Exploitable N
Page 25 and 26: New Attack Classes - Vector Rewrite
Page 27 and 28: New Attack Classes - Prevention•
Page 29 and 30: System-On-Chip Designs• Many chip
Page 31 and 32: Exploitation (ARM)• The ARM proce
Page 33 and 34: ExploitationTwo Step Exploitation1
Page 35 and 36: Exploitation (ARM)Set remote config
Page 37 and 38: Exploitation• Successful exploit
Page 39 and 40: Firmware PatchConsiderations:• Ne
Page 41 and 42: Injector 2.0• Watch for downloads
Page 43 and 44: Exploit DemonstrationDEMO!Copyright
Page 45 and 46: Summary• Security flaws are abund

EXPLOITING EMBEDDED SYSTEMS THE SEQUEL!

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?