brinkmann - Ramirent

3 Technical description
Protective guard
(V-belt)
Maintenance fl ap
(power belt)
BRINKMANN
MASCHINENFABRIK GMBH & CO. KG
The V-belt on the dynamo is covered by a protective guard (1), to
prevent personnel from reaching into the moving V-belt while the
machine is operating (e.g. during brief visual inspections). Always attach
the protective guard (1) correctly before starting the machine.
Danger ––––––––––––––––––––––––––––––––––––––––––––––––––––––
Always attach the protective guard correctly before starting the
machine's engine. In addition, refi t the protective guard correctly before
starting the engine for function checks. Never remove the protective
guard without fi rst disconnecting the battery on the machine.
See Chapter 7.6 Shutting down the machine. Ignoring this instruction
may cause serious injuries.
The protective grille may be removed only for maintenance or cleaning
work and must be refi tted correctly immediately after the work is complete.
The automatic V-belt release and the power belt (3) on the mixer drive
are located behind the maintenance fl ap (2) above the mixing tank together
with the check valves (4) on the header and fl otation air lines.
Danger ––––––––––––––––––––––––––––––––––––––––––––––––––––––
Do not operate the machine while the maintenance fl ap is open. Do not
open the maintenance fl ap without fi rst disconnecting the battery on
the machine. See Chapter 7.6 Shutting down the machine. Ignoring this
instruction may cause serious injuries.
The maintenance fl ap may be opened only for maintenance, cleaning or
repair work and must be closed immediately after the work is complete.
1 2 3 4
3 - 8 03DF001_0608_en