brinkmann - Ramirent

3 Technical description
Automatic central
lubricating system
Automatic pressure
cut-out
BRINKMANN
MASCHINENFABRIK GMBH & CO. KG
A piston pump assembly lubricates the following important mixing shaft
components automatically:
− Front and rear mixing shaft seals
− Rear mixing shaft bearing
The central lubrication system can be operated from the control panel if
necessary, e.g. after repairs or after inserting a new grease cartridge.
Check the quantity of grease in the distributor on a daily basis. Top up
the distributor when the grease reaches the min. mark.
The grease in one cartridge should be suffi cient for approx. one year of
normal operation.
Maintenance card 03-001 Central lubrication system
Note –––––––––––––––––––––––––––––––––––––––––––––––––––––––
The front mixing shaft bearing must be lubricated every three months.
The lubricating point is located next to the grease distributor for the
central lubricating system. MC Central lubrication system.
The compressor is switched off via a pressure monitor before the mixing
tank is depressurised. The standard setting for the automatic pressure
cut-out is 2 bar. Chapter 5.13 Setting the ventilation pressure.
Advantages:
− The operator can leave the machine once the delivery cycle has
started.
− The delivery lines are not emptied, which prevents the mixture from
segregating.
− The delivery cycle fi nishes in good time.
The speed of the turbo engine on the DC 260/55 decreases by 30%,
which reduces noise emissions, fuel consumption and tank wear.
3 - 12 03DF001_0608_en