A Starters Guide on Compression Moulding And Autoclave

| Editor’s Note |
A Starter’s <strong>Guide</strong>
This edition features two key machinery used in the
rubber industry viz. Autoclave and Compression
Moulding.
Autoclave is a vulcanizing equipment, and the other
is the equipment used in your most common rubber
moulding technique - compression moulding. These
contents first appeared on our portal and witnessed
high traffic.
This high interest level, prompted us to publish the
details in this Knowledge On-The-Go Special
Supplement.
Our previous issue on Mixing Mills was well-received.
Thanks again to each of you - esteemed readers and
supportive advertisers.
While, the last edition was tracking the advancements
of a very popular rubber machinery, this edition is
aimed at fulfilling the curiosity of the new generation
of business leaders - who are either taking over from
their parents or those young entrepreneurs setting up
their own venture.
Hence, the theme - ‘A Starter’s <strong>Guide</strong>’.
Autoclave is a
vulcanizing
equipment, and the
other is used in your
common rubber
moulding technique
viz. compression
moulding.
3
I hope you find this special supplement different and
informative.
As always, I welcome your feedback on
rubbermachineryworld@gmail.com.
rubbermachineri
rubbermachineryworld
+Rubbermachineryworld1
BestRegards
Prasanth Warrier
grp/home?gid=8252803
rubbermachineri
Special Supplement - Rubber Machinery World | OCT 2015