A200 - Electrical Part Manuals

More documents

Recommendations

Info

Page 18 Type MOR Modular Overload Relay Underload Module being added to MOR Relay Special Function Plug-in Modules Phase Unbalance Module (PUM) The Phase Unbalance Module is a plug-in module providing complete protection against phase failure, phase unbalance and low level ground fault protection. The PUM senses phase-to-phase relationship and sends an instantaneous trip signal if the phases are unbalanced by 10%. list Price: $140 each. Discount C1 0-S1 9 Catalog Number: PU M List Price Addition for LED: $1 0 C10-519 Catalog Number: PUM-L _� __ Permissive Running and 75 25 1# 1)2 1- Current, % of '-leater ROling Acceleration No Trip Zone www . ElectricalPartManuals . com
e Accessories l-56 Electr ical Interlock Description L-56 electrical interlocks are designed to be used as auxiliary control contacts for West inghouse A/200 contactors. One interlock fits all sizes from 00-4. Because the L-56 mounts within the outside dimension of the contactor, four interlocks per contactor can be added without any increase in panel area. The L-56 is held in position by two attached spring clips so no mounting hardware or tools are required. For easy wiring, inter locks are designed to mount in either of two 90' positions, whichever is more convenient to the user. See illustration. Mounting Positions and Number Interlocks may be mounted as indicated by black squares. Non-reversing Starters and Contactors Sizes 00, ° and 1 Sizes 00, ° and 1 1, 2, 3 Pole 4, 5 Pole Sizes 2, 2 and 4 2, 3, 4, 5 Pole C D Reversi ng, Two -Speed and Mechanically Interlocked Contactors All Sizes All Sizes Horizontal Vertical list Prices Discount C1 0-S5 Catalog Number L-56 L-56B L-56C L-56D L-56E L-56F L-56G L-56M Type Contacts 1 NO, 1 NC 2NO 2NC lNO lNC 1 NO Early Make, 1 NO 1 NC Delayed Break, 1 NO 1 NC Delayed Break, plus 1 NC Switching Ratings List Price $12.00 16.00 16.00 12,00 12.00 16.00 16.00 16.00 Load Voltage Current (Amperes) � ... -�� ... - - Inrush Normal Inductive, Ac 110-125 30 3 220-250 15 1.5 440-480 7,5 .75 550-600 6 .6 Dc 115-125 1.1 230-250 .55 550-600 .2 Contln-.lous current carryiqg capacity 10 amperes maximum. Mechanical Interlocks Horizontal Design Description The mechanical interlock for A/200 devices is a self contained unit either factory assembled on complete reversing or multispeed devices or is available in kit form for field mounting, The mechanical interlock is a lever type mechanism which prevents any closing motion of one member of a reversing or multi-speed contactor or motor controller, until the opposing member is essentially completely open. list Prices Discount C1 0-S5 Contactor Arrangement Interlock Cant. (No. of Horiz. or Cat. No. Size 3X3 Horizontal M-33-1 A 0, 1 4X4 Horizontal M-33-1A 0, 1 5X3 Horizontal M-33-1A 0, 1 All Pole Cob" Vert. M-34-1 0, 1 3X3 Vert. Rev. M-33-2A 2 3X3 Vert. Rev. M-34-2 2 5X3 Horizontal M-35-2 2 4X4 Horizontal M-36-2 2 All Pole Comb, Horiz. M-33-3A 3, 4 All Pole Comb. Vert. M-34-3 3, 4 @ Cannot be mounted i n thi s position on Size 2 contactors and starters . list Price $1 2 12 12 12 12 12 12 12 20 20 8220 C WEA Catalog Section Page 19 Time Delay Interlock The Westi nghouse solid state time delay interlock provides accurate, re liable timing in a minimum of panel space. Field mountable in the interlock cavity of A/200 starters and contactors, it has one NO contact. Designed to switch a 120 volt Ac coil. it may be wired in series with the starter or contactor coil. It is also available with a mounting plate for panel use. list Prices Discount C1 0-S5 Number Starter or Contactor Mounting On Delay TON-56 Off Delay TOF-56 Panel Mounting On Delay TO N-56P Off Delay TOF-56P Ratings Time Delay Range: 0.2 to 30 seconds. Power Requirement: 2 VA list Price $72 72 Power Rating: Sufficient to drive sizes 00-4 contactors (ex. 4, 5 pole, sizes 3, 4). Voltage Rating: 120 Ac, +10% @ 50-60 Hz. Solid State Contacts: 0.5 amps inductive load (5.8 amps max. inrush) Recycling Speed: 150 operations per minute, max. 78 78 Ambient Temp, Range: -20·C to 60·C. Repeat.: ± 2% with voltage variation ± 10%. Reset Time On Delay: 8 ms. after time out, 2 seconds before time out. Min, Energ _ Time Off Delay: 0.1 seconds. Mounting Positions (see drawing). Starters: Two top positions only. Contactors: All positions Interlock Must be Mounted as Indicated www . ElectricalPartManuals . com
Page 1 and 2: www . ElectricalPartManuals . com
Page 3 and 4: A900 Multi-speed, 2 Speed Starters
Page 5 and 6: A201 Non-Reversing Contactors Field
Page 7 and 8: A211 Mechanically Interlocked Conta
Page 9 and 10: A231 , 3 Way Interlocked Starter Th
Page 11 and 12: Type A Overload Relays, Single Pole
Page 13: Type MOR Modular Overload Relay The
Page 17 and 18: Field Modification Kits Mechanical
Page 19 and 20: Factory Modifications To indicate a
Page 22: www . ElectricalPartManuals . com
Page 25 and 26: September 28, 1976 New Information
Page 27: Westinghouse • Starters for Hazar
Page 30 and 31: Catalog Section 8220 Page 44 Westin
Page 33: Catalog Section 8220 Page 47 Low Vo
Page 36: Catalog Section 8220 Page 50 Westin
Page 45 and 46: Reversing Combination Starters List
Page 47: Reversing Combination Starters List
Page 51 and 52: Catalog Section 8220 Page 39 Low Vo
Page 53 and 54: Typical Wiring Diagrams �B �l S

A200 - Electrical Part Manuals

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?