Operation Manual EMH-COM - Imbema Belgium

More documents

Recommendations

Info

42 Program description MO Menu option Enter new product key... Entering a new product key for releasing further program modules Info > Enter new product key... Procedure: The release of new program modules takes place as described in chapter Release, page 12. MO Menu option Release product key... Requesting a new key code and releasing further program modules Info > Release product key... Procedure: The release of new program modules takes place as described in chapter Release, page 12.
Questions and answers 1. No communication to the meter takes place. After a few seconds the announcement Timeout in the communication, Login not possible appears. Possible causes : - The optical communication adapter is not attached properly or not connected correctly. - The interface is not set correctly. When using an optical communication adapter OKK please check the information for the <strong>COM</strong>-Port in the menu Settings. Perhaps you must select another <strong>COM</strong>-Port. - The baud rate is not selected correctly. When using an optical communication adapter OKK select in the menu Settings-Mode C. With this setting, the PC and the meter set the optimal baud rate themselves. 2. Communication with the meter takes place however, the read out seems to be faulty. After ending the communication the error announcement appears that the BCC check was incorrect. Possible causes : - With laptops the energy saving function can be activated which switches off the hard disc after a certain period of time. If a hard disc access then takes place (e.g. for the saving of storage area elsewhere), it is not possible to access the hard disc immediately. Delays in the program operation then occur and this can cause reading errors. In this case deactivate the energy saving function via Start > Settings > Control Panel > Power Options. - Your PC does not have enough RAM (Random Access Memory). If less than 32 MB are installed then often the RAM has to be put on to a hard disc. With some computers, due to delays, reading mistakes are caused. - The Buffer (FIFO) of the serial interface has not been set correctly. With transmission problems try out different settings. Unfortunately a general setting tip cannot be given. - When using a laptop and a passive optical communication adapter OKK then, due to a reduced voltage supply, the voltage at the serial interface is no longer enough for a faultless data transmission. In this case we recommend using an optical communication adapter OKK with an USB connection. Program description 43
Page 1 and 2: Operation Manual EMH-COM Communicat
Page 3 and 4: Table of Contents Chapter 1: Prolog
Page 5 and 6: Chapter 1: Prologue The EMH-COM sof
Page 7 and 8: Chapter 2: Installation and release
Page 9 and 10: In the following window the program
Page 11 and 12: At the end of the installation the
Page 13 and 14: Start the EMH-COM. The following wi
Page 15 and 16: The printer menu from your standard
Page 17 and 18: Communication requirements There ar
Page 19 and 20: Program Description M Menu File Tra
Page 21 and 22: MO Menu option Identity numbers...
Page 23 and 24: MO Menu option Single commands...
Page 25 and 26: MO Menu option Load profile ... Rea
Page 27 and 28: MO Menu option Verification log boo
Page 29 and 30: Attention: After a conversion for a
Page 31 and 32: Total evaluation complete LP � In
Page 33 and 34: M Menu Setting Setting Setting poss
Page 35 and 36: R Register Modem Setting of the loc
Page 37 and 38: R Register Representation Sets the
Page 39 and 40: R Register Export format Setting th
Page 41: M Menu Info Program information and
Page 45 and 46: Events can occur within a measuring
Page 47 and 48: 5. In the following window click on
Page 49 and 50: 9. In the following window you must

Operation Manual EMH-COM - Imbema Belgium

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?