Chevrolet 2016 Malibu Limited - View Owner's Manual
Chevrolet 2016 Malibu Limited - View Owner's Manual
Chevrolet 2016 Malibu Limited - View Owner's Manual
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
130 Instruments and Controls<br />
reverse feature. This includes any<br />
garage door opener model<br />
manufactured before April 1, 1982.<br />
Read these instructions completely<br />
before programming the Universal<br />
Remote system. It may help to have<br />
another person assist with the<br />
programming process.<br />
Keep the original hand-held<br />
transmitter for use in other vehicles<br />
as well as for future programming.<br />
Erase the programming when<br />
vehicle ownership is terminated.<br />
See “Erasing Universal Remote<br />
System Buttons” later in this<br />
section.<br />
To program a garage door opener,<br />
park outside directly in line with and<br />
facing the garage door opener<br />
receiver. Clear all people and<br />
objects near the garage door.<br />
Make sure the hand-held transmitter<br />
has a new battery for quick and<br />
accurate transmission of the<br />
radio-frequency signal.<br />
Programming the Universal<br />
Remote System<br />
For questions or help programming<br />
the Universal Remote system, call<br />
1-800-355-3515 or see<br />
www.homelink.com.<br />
Programming involves<br />
time-sensitive actions, and may time<br />
out causing the procedure to be<br />
repeated.<br />
To program up to three devices:<br />
1. Hold the end of the hand-held<br />
transmitter about 3 to 8 cm (1<br />
to 3 in) away from the<br />
Universal Remote system<br />
buttons with the indicator light<br />
in view. The hand-held<br />
transmitter was supplied by the<br />
manufacturer of the garage<br />
door opener receiver.<br />
2. At the same time, press and<br />
hold both the hand-held<br />
transmitter button and one of<br />
the three Universal Remote<br />
system buttons to be used to<br />
operate the garage door. Do<br />
not release either button until<br />
the indicator light changes from<br />
a slow to a rapid flash. Then<br />
release both buttons.<br />
Some garage door openers<br />
may require substitution of<br />
Step 2 with the procedure<br />
under “Radio Signals for<br />
Canada and Some Gate<br />
Operators” later in this section.<br />
3. Press and hold the newly<br />
programmed Universal Remote<br />
system button for five seconds<br />
while watching the indicator<br />
light and garage door<br />
activation.<br />
. If the indicator light stays on<br />
continuously or the garage<br />
door moves when the<br />
button is pressed, then<br />
programming is complete.<br />
There is no need to<br />
complete Steps 4–6.<br />
. If the indicator light does<br />
not come on or the garage<br />
door does not move, a<br />
second button press may<br />
be required. For a second<br />
time, press and hold the<br />
newly programmed button