UT Testing-Section 2 Physics of Ultrasound

More documents

Recommendations

Info

Q: When angle beam contact testing a test piece, increasing the incident angle until the second critical angle is reached results in: A. Total reflection of a surface wave B. 45 degree refraction of the shear wave C. Production of a surface wave D. None of the above
Page 1:
Section 2: Physics of Ultrasound
Page 4 and 5:
2.0: Ultrasound Formula http://www.
Page 6 and 7:
Ultrasonic Formula
Page 9 and 10:
2.1: Wave Propagation Ultrasonic te
Page 11 and 12:
Acoustic Spectrum
Page 13 and 14:
Acoustic Wave - Node and Anti-Node
Page 15 and 16:
http://hyperphysics.phy-astr.gsu.ed
Page 17 and 18:
2.2: Modes of Sound Wave Propagatio
Page 19 and 20:
Longitudinal and shear waves
Page 21 and 22:
Longitudinal and shear waves
Page 23 and 24:
2.2.3 Longitudinal Wave Also Knows
Page 25 and 26:
Longitudinal wave: Longitudinal wav
Page 28 and 29:
2.2.4 Shear waves (S-Waves) In air,
Page 30 and 31:
Shear waves
Page 33 and 34:
Q10: For a shear wave travelling fr
Page 35 and 36:
Rayleigh waves are a type of surfac
Page 37 and 38:
Q29: The longitudinal wave incident
Page 39 and 40:
The major axis of the ellipse is pe
Page 41 and 42:
Surface wave
Page 43 and 44:
Surface wave has the ability to fol
Page 45 and 46:
Surface wave - One wavelength deep
Page 47 and 48:
Love Wave http://web.ics.purdue.edu
Page 49 and 50:
Other Reading: Rayleigh Waves Surfa
Page 51 and 52:
Q110: What kind of wave mode travel
Page 53 and 54:
2.2.6 Lamb Wave: Lamb waves propaga
Page 55 and 56:
Types of Wave New! • Plate wave-
Page 57 and 58:
Plate or Lamb waves are similar to
Page 59 and 60:
With Lamb waves, a number of modes
Page 61 and 62:
Symmetrical = extensional mode Asym
Page 63 and 64:
Symmetrical = extensional mode
Page 65 and 66:
The form is determined by whether t
Page 67 and 68:
Q1: The wave mode that has multiple
Page 69 and 70:
Dispersion refers to the fact that
Page 71 and 72:
Thickness Limitation: One can not g
Page 73 and 74:
Spring model- A mass on a spring ha
Page 75 and 76:
In terms of the spring model, Hooke
Page 77 and 78:
Elastic Model / Longitudinal Wave
Page 79 and 80:
Elastic Model / Shear Wave
Page 81 and 82:
The Speed of Sound Hooke's Law, whe
Page 83 and 84:
What properties of material affect
Page 85 and 86:
Where V is the speed of sound, C is
Page 87 and 88:
Q50: The principle attributes that
Page 89 and 90:
E/N/G
Page 91 and 92:
Examples of approximate compression
Page 93 and 94:
Shear Wave Velocity: V S The veloci
Page 95 and 96:
The applet below shows a longitudin
Page 97 and 98:
http://www.ndt-ed.org/EducationReso
Page 99 and 100:
Java don’t work? http://jingyan.b
Page 101 and 102:
Java don’t work? http://jingyan.b
Page 103 and 104:
As can be noted by the equation, a
Page 105 and 106:
The two velocities of sound are lin
Page 107 and 108:
Sensitivity and resolution are two
Page 109 and 110:
2.5.2 Grain Size & Frequency Select
Page 111 and 112:
Since more things in a material are
Page 113 and 114:
Detectability variable: • pulse l
Page 115 and 116:
Q7: When a material grain size is o
Page 117:
Pulse Length: A sound pulse traveli
Page 120 and 121:
Determining cross sectional area us
Page 122 and 123:
Pulse volume rule-of-thumb: Competi
Page 124 and 125:
When sound travels through a medium
Page 126 and 127:
Scattering: Grain Size and Wave Fre
Page 128 and 129:
Spreading/ Scattering / adsorption
Page 130 and 131:
The units of the attenuation value
Page 132 and 133:
Attenuation can be determined by ev
Page 134 and 135: A o Ut A
Page 137 and 138: 2.6.3 Frequency selection There is
Page 139 and 140: Q94: In general, which of the follo
Page 141 and 142: Q7: When the material grain size is
Page 143 and 144: Transmission & Reflection Animation
Page 145 and 146: The following applet can be used to
Page 147 and 148: Reflection/Transmission Energy as a
Page 149 and 150: 2.8: Reflection and Transmission Co
Page 151 and 152: Since the amount of reflected energ
Page 153 and 154: Note that the reflection and transm
Page 155 and 156: If reflection and transmission at i
Page 157 and 158: Incident Wave other than Normal? -
Page 159 and 160: Further Reading (Olympus Technical
Page 161 and 162: Further Reading: Reflection & Trans
Page 163 and 164: 2.9: Refraction and Snell's Law
Page 165: V s1 Only If this medium support sh
Page 168 and 169: http://www.ni.com/white-paper/3368/
Page 172 and 173: Note that in the diagram, there is
Page 174 and 175: Snell Law
Page 176 and 177: Snell Law
Page 178 and 179: Example: Snell’s Law L-wave and S
Page 180 and 181: Snell Law: First critical angle
Page 182 and 183: Q155 Which of the following can occ
Page 191 and 192: Typical angle beam assemblies make
Page 193 and 194: Depth & Skip
Page 195 and 196: Second Critical Angle The second cr
Page 197 and 198: 2.10: Mode Conversion When sound tr
Page 199 and 200: In the previous section, it was poi
Page 201 and 202: Snell's Law
Page 203 and 204: Reflections
Page 205 and 206: V S1 V S2
Page 207 and 208: Snell Law- 1 st & 2 nd Critical Ang
Page 209 and 210: Transverse wave can be introduced i
Page 211 and 212: Calculate the offset for following
Page 213 and 214: Refraction and mode conversion at n
Page 215 and 216: Refraction and mode conversion at n
Page 217 and 218: Q1. From the above figures, if the
Page 219 and 220: Q: On Calculation: Incident angle=
Page 221 and 222: Q1. If you were requested to design
Page 223 and 224: 2.11: Signal-to-Noise Ratio In a pr
Page 225 and 226: The following formula relates some
Page 227 and 228: Rather than go into the details of
Page 230 and 231: Determining cross sectional area us
Page 232 and 233: “Sonic pulse volume” and S/N (d
Page 234 and 235:
Pulse Length
Page 236 and 237:
2.12: The Sound Fields 2.12.1 Wave
Page 238 and 239:
When waves interact, they superimpo
Page 240 and 241:
UT Transducer http://www.fhwa.dot.g
Page 242 and 243:
UT Transducer
Page 244 and 245:
Wave Interaction Complete in-phase
Page 246 and 247:
With an ultrasonic transducer, the
Page 248 and 249:
29. It is possible for a discontinu
Page 250 and 251:
2.12.2 Variations in sound intensit
Page 252 and 253:
The sound wave exit from a transduc
Page 254 and 255:
The Near Field (Fresnel) and the Fa
Page 256 and 257:
Amplitude ← Near Field Effect: Be
Page 258 and 259:
Near field (near zone) or Fresnel z
Page 260 and 261:
Near/ Far Fields http://miac.unibas
Page 262 and 263:
where α is the radius of the trans
Page 264 and 265:
The curvature and the area over whi
Page 266 and 267:
Fresnel & Fraunhofer Zone
Page 268 and 269:
Fresnel & Fraunhofer Zone http://st
Page 270 and 271:
Q4: A transducer has a near field i
Page 272 and 273:
2.12.4 Dead Zone In ultrasonic test
Page 274 and 275:
Dead Zone -The initial pulse is a t
Page 276 and 277:
Dead Zone Illustration http://www.n
Page 278 and 279:
Q: On an A-scan display, the “dea
Page 280 and 281:
2.13: Inverse Square Rule/ Inverse
Page 282 and 283:
Small Reflector, a reflector smalle
Page 286 and 287:
2.14: Resonance Another form wave i
Page 288 and 289:
Thickness of Crystal at Fundamental
Page 290 and 291:
Resonance UT Testing- The diagram b
Page 292 and 293:
From the natural frequencies it is
Page 294 and 295:
Q: The formula used to determine th
Page 296 and 297:
2.15 Measurement of Sound
Page 298 and 299:
Ultrasonic Formula - Signal Amplitu
Page 300 and 301:
where: delta X is the difference in
Page 302 and 303:
From this table it can be seen that
Page 304 and 305:
However, the power or intensity of
Page 306 and 307:
Revising the table to reflect the r
Page 308 and 309:
Sound Levels- Relative dB
Page 310 and 311:
“Absolute" Sound Levels Sound pre
Page 313 and 314:
dB meter 97.3dB against standards s
Page 315 and 316:
Exercise: Find the absolute sound l
Page 317 and 318:
Practice: dB
Page 319 and 320:
Example Calculation 2 If the intens
Page 321 and 322:
What is the absolute rock concert s
Page 323 and 324:
Practice Makes Perfect 28. An advan
Page 325 and 326:
学习总是开心事
Page 327 and 328:
Page 329 and 330:
Page 331 and 332:
Page 333:
show all

UT Testing-Section 2 Physics of Ultrasound

Create successful ePaper yourself

Delete template?

Save as template?