User Guide Pulpmatic Uno V2.1
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
7.3 Lid operation<br />
The operation of the <strong>Pulpmatic</strong> lid is completely hands free and fully automatic. This machine<br />
includes a number of important safety features:<br />
Automatic Close:<br />
The lid will automatically close 60 seconds after the footswitch is operated.<br />
An audible tone will alert the user as the lid starts to close. The lid close<br />
action can be aborted and the lid opened by inserting a foot into the foot<br />
cup. If the auto close auto start is enabled the lid open time can be reduced.<br />
Automatic Open:<br />
If the lid is obstructed during the closing motion, inbuilt sensors detect the<br />
obstruction and reverse the motor and open the lid.<br />
Safety Locks:<br />
The lid is automatically locked during the chopping/cutting cycle and will not<br />
be released until the cycle is complete.<br />
7.4 Loading the machine<br />
The foot cup will not respond and the lid will not open until the machine has completed the<br />
previous cycle.<br />
Once the lid is open check the chamber is clear, place the waste items into the machine and hold<br />
your hand over the green Start light, the lid will close and the disposal cycle will start. The machine<br />
can be left to complete the cycle with no further action from the user.<br />
Pulp & maceratable products should be placed carefully into the chamber; care should be taken to<br />
avoid spillage or splashing over the machine. Any spillage should be wiped clean immediately.<br />
Large volumes of toilet paper or maceratable wipes will reduce the overall load capacity of the<br />
machine. If these items are used in great quantity we recommend running more frequent cycles to<br />
ensure the load can be effectively cleared.<br />
If the machine is overloaded it may not clear the contents of the chamber in a single cycle.<br />
Running a second cycle should clear the chamber. Severe overloading may engage the safety cut<br />
out system and produce an F2 code on the display (please see page 29).<br />
Copyright © 2015 DDC Dolphin Ltd. Page 21 of 36 December 15 UG-<strong>Uno</strong>-<strong>V2.1</strong>