Service%20Manual%20DW20%20EN
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
4.4 Water level DW20<br />
When servicing DW20 dishwashers, it is<br />
important to check the water level in the<br />
machine.<br />
This is particularly important when programming<br />
the time-controlled water intake. Too low a water<br />
level can cause poor dishwashing results.<br />
Always allow the machine to take in and<br />
pump out water a few times before checking<br />
the level.<br />
Overflow level = 6.5 litres<br />
Without Spray arm diverter = 3.1<br />
litres (1.5 mm above the level)<br />
With Spray arm diverter = 2.7 litres<br />
(0.5 mm below the level)<br />
Check the level at the lower wash tower<br />
In the event of too low a water level, the filter in<br />
the inlet valve must always be checked and<br />
rinsed clean of any dirt. An inlet hose with a ¾”<br />
connection at both ends has a filter in the<br />
connection outside the machine and must be<br />
checked and rinsed clean of any dirt.<br />
When inserting a new inlet valve, it is<br />
recommended that the machine always be<br />
programmed for volume-controlled water intake<br />
or for increasing or decreasing the water level.<br />
See the service manual or installation instructions<br />
for guidance.<br />
31