quality-indicators-2017
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
QUALITY INDICATORS <strong>2017</strong><br />
which no data could be obtained and the number of all units eligible for this variable 1 . In using administrative<br />
data, the indicator value calculated is the unsuccessful record linkage rate, which shows the percentage of units<br />
which we were not able to successfully link when using one or more administrative sources; consequently, the<br />
value of the variable could not be determined.<br />
The indicator value refers to the key variable.<br />
3.6.2 Calculation procedure<br />
Y<br />
rsp<br />
, Y<br />
nrsp<br />
and Yelig<br />
Yrsp<br />
Ynrsp<br />
should be the number of responses, non-responses and eligible units for the<br />
selected variable Y . Then, we calculate the weighted and unweighted values of the indicator as stated below.<br />
3.6.2.1 Unweighted rate<br />
T 3<br />
Y<br />
Y nrsp<br />
1<br />
Y<br />
elig<br />
Y<br />
<br />
Y<br />
rsp<br />
elig<br />
3.6.2.2.Weighted rate<br />
The weighted rate is calculated by the following formula:<br />
Y<br />
nrsp<br />
<br />
w<br />
j<br />
x<br />
j<br />
Y<br />
T 3 <br />
, where<br />
ut<br />
j1<br />
Y<br />
elig<br />
<br />
j1<br />
w x<br />
j<br />
j<br />
w<br />
j<br />
is the final unit weight,<br />
x<br />
j<br />
is the value of the auxiliary variable.<br />
Unlike the unit non-response rate, in this case the final weight (and not the sample weight) is used because the<br />
observation units deemed to be non-responses (i.e. as units from which we were not able to obtain the relevant<br />
data) are usually also included in the procedure for calculating the final weight and therefore they cannot be<br />
weighted with this final weight. On the contrary, the partial response belongs to units that have already been<br />
weighted by the final weight, therefore the final weight can also be used for the calculation of the item nonresponse<br />
rate.<br />
If we take X 1<br />
as the auxiliary variable, we obtain the weighted rate calculated only on the basis of the final<br />
weight:<br />
<br />
<br />
w<br />
Y j<br />
Y<br />
nrsp<br />
T 3<br />
ut<br />
.<br />
w<br />
Y<br />
elig<br />
j<br />
In cases where for each unit the final weight is w 1 :<br />
<br />
<br />
x<br />
Y j<br />
Y<br />
nrsp<br />
T 3<br />
ut<br />
.<br />
x<br />
Y<br />
elig<br />
j<br />
j<br />
1 For the response of an eligible unit among all responses ( n<br />
rsp<br />
) as defined for indicator T2 (see 3.5).<br />
16