SA_VOL2 EMPLOYED

효율적인 유지관리및 에너지 수율의 이유로 인해 직사각형의 형상을 가지는 기성품 photovoltaic panel들을 사용하게 됩니다. Dubai의 모래먼지가 많은
환경에서 pv panel 들의 청소및 유지관리는 또다른 중요한 고려 요소가 되며, 이를 위해 각 pv panel들은 panel 의 양끝단에 위치한 maintenance gutter 위에
앉혀집니다. 아래의 process는 초기의 gutter로부터 pv panel의 길이를 고려한 특정한 거리상에 다음번의 gutter의 위치를 정하기 위한 geometric rule을
설명하고 있습니다.
STEP 08_CATWALK GEOMETRY SET OUT
Catwalk Assemblies
Clearance Surface for Catwalk
Top Chord Surface
Bottom Chord Surface
Circle line to start Catwalk Assemblies
Goals
A: Keep the distance for the ‘PV Cassettes’ consistently between ‘Catwalk Assemblies’
B: Maintain a constant clearance from the ‘Canopy truss structural top surface’ to the ‘PV Ring beams’
C: Keep a single ‘Catwalk / Gutter’ cross section and orientation at all locations
Process
1) Offset upper chord surface by required clearance
3) Create circle with a radius equal to the target span for the PV Cassettes centered on the center of the ring beam or lowest required
point for clearance
4) Move the circle over on the axis of the gutter's walkable surface by the length of the catwalk opening in the direction of the next
segment. This will account for the plank being "layed" from the right hand side of the lower gutter assembly vto the left hand side of
the next gutter assembly above
5) Intersect this circle with the offset curve to get next placement point
6) Translate the cross section from the center point of the ring beam to the new intersection point.
PROCESS 01
Critical Dimension
PROCESS 02
Effective Range
Clearance
PROCESS 03 : Move Circle to bottom point of Catwalk
PROCESS 04
X
X
PROCESS 05
PROCESS 06
ib
Next Origin
Critical Dimension
On Curve