Manual do CLP linha XGK

Chapter 4 CPU Module
No. Names Description
You can enable/disable Reset/D.Clear switch in “XG5000 Basic Parameter
Basic Operation Setup”
1. When Reset switch is enabled
Operation
Result
move to left return to center
move to left keep 3 seconds or
above return to center
Reset
Overall reset
4
Reset/ D.Clear
switch
2. When D.Clear switch is enabled
Operation
move to right return to center:
move to left keep 3 seconds or
above return to center:
Result
General data area and retain area
(M, Automatic variable) will be
cleared.
General data area, retain area (M,
Automatic variable) and R area will
be cleared.
• Note: DATA CLEAR acts only in “STOP” operation mode.
5 USB connector A connector to connect with peripherals (XG5000 etc.) (USB 1.1 support)
6
7
RS−232C connector
Battery built-in
cover
A connector to connect with peripherals
• XG5000 connection: support basically
• Modbus equipment connection: Modbus protocol support(Only as Server)
TX: no.7 Pin, RX: no.8 Pin, GND: no.5 Pin
Back-up battery built-in cover
4- 7