3 Wireless Remote Control CZone LCD QVGA ... - BUKH Bremen

Voltage Sensitive Relays
High cur rent remote oper ated ( VSR)
Range HigHligHts
Dual battery sensing
Remote emergency parallel function:
the 701-MDVS and 720-MDVS can be
operated through a momentary button
on the dash which will parallel the
batteries for a preset time of 10 minutes.
Once this 10 minutes has passed, if the
voltage is up high enough for the voltage
sensitive switch to operate, it will stay
engaged. If not, it will disengage.
Engine run sensing: VSR will engage
when the voltage on either start or
house battery reaches 13.7 volts. If the
combined battery voltage drops below
13.0 volts and the engine is not running,
after 5 seconds the contacts will open
and stay open until the start or house
battery voltage exceeds 13.7 volts. If the
combined battery voltage drops below
12.2 volts and the engine is running, after
5 minutes the contacts will open and stay
open until the start or house battery
voltage exceeds 13.7 volts. If voltage
drops below 13 volts and stays above12.2
volts on either start or house battery
while engine is running, the VSR will stay
engaged.
Manual override option
The advantages of using a high current
VSR is that it will cover your dual battery
charging requirements and emergency
parallel operation in one unit.
High Current Remote operated VSR
Part No. mm
in
L x W x H L x W x H
701-MDVS 68 x 68 x 101 2.7 x 2.7 x 4
720-MDVS 102 x 102 x 110 4 x 4 x 4.3
701-MDVS-24V 68 x 68 x 101 2.7 x 2.7 x 4
720-MDVS-24V 102 x 102 x 110 4 x 4 x 4.3
80-701-0018-00 68 x 68 x 101 2.7 x 2.7 x 4
80-720-0018-00 102 x 102 x 110 4 x 4 x 4.3
High Current Remote operated VSR
Part No. Volts Rating Engages Disengages
(V) (A) (V DC) (V DC)
701-MDVS 12 275 13.7 12.2 - 13.00
720-MDVS 12 500 13.7 12.2 - 13.00
701-MDVS-24V 24 275 27.4 24.4 - 26.00
720-MDVS-24V 24 500 27.4 24.4 - 26.00
80-701-0018-00 12/24 275 Emergency Parallel Only
80-720-0018-00 12/24 500 Emergency Parallel Only
701-MDVS
Also available in
Emergency parallel only
(no voltage sensitive
function). See table.
OUTPUT
INPUT
48 LEADING ELECTRICAL DESIGN
80-724-0007-00
RED
GREEN
BLACK
IT IS IMPERATIVE THAT THE NEGATIVE (BLACK) FOR THE MD/MDVS IS TAKEN
FROM THE SAME BATTERY THAT IT IS ISOLATING. FAILURE TO
DO THIS WILL CAUSE THE UNIT TO WORK ERRATICALLY. ONLY ONE NEGATIVE
MUST BE SUPPLIED TO EACH UNIT FOR CORRECT OPERATION.
Dual operation VSR
and Emergency Parallel
The High Current Remote
Operated VSR (Voltage Sensitive
Relay), uses the same operation
as the motor driven Battery
Switches.
For the remote operation of the 701-MDVS and 720-MDVS voltage
sensitive battery switches. It can be mounted standalone or within the
Contour Connect panel range.
80-724-0006-00
701
701
(ON)/OFF
SWITCH
THESE TWO CABLES MUST BE
TERMINATED INTO WAGO PLUG
720-MDVS