1-10V - Philips Lighting

More documents

Recommendations

Info

18 8.5 Multiple sensor on multiple SwitchBoxes with one or more 0-10V ballasts or drivers Sensor SwitchBox Sensor Sensor Philips ActiLume 1-10V OEM Application Guide SwitchBox 0-10V ballast or driver 0-10V ballast or driver 0-10V ballast or driver 0-10V ballast or driver SwitchBox 0-10V ballast or driver This setup is possible with some restrictions. 1 The number of sensors is maximum two times the number of SwitchBoxes 2 Only one sensor can act as a daylight sensor. All other daylight sensors have to be switched off, so put all sensors into Setting I except for one sensor that can act as the daylight regulating sensor and has therefore to be put into setting II. If no daylight regulation is requested than put all sensors into Setting I. The concern in this case is that if one sensor will detect no presence during the delay time set by the delay-timer, all SwitchBoxes will be forced into a dim-level related to 2.5V on the dim-input and will be switched off at the end of the dimming down sequence.
Philips ActiLume 1-10V OEM Application Guide 19
Page 1 and 2: ActiLume 1-10V OEM Application Guid
Page 3 and 4: 1. What is the ActiLume 1-10V Syste
Page 5 and 6: Though the sensor has a radial reac
Page 7 and 8: SwitchBox + - Sensor ON DC in 2 1 T
Page 9 and 10: 3. ActiLume 1-10V User Modes Actilu
Page 11 and 12: 5. Commissioning Commissioning is i
Page 13 and 14: When a sensor is clipped on the lam
Page 15 and 16: If the sensor is accidently connect
Page 17: 8.3 Multiple sensors on one SwitchB

1-10V - Philips Lighting

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?