Rockford Systems Shields for Safeguarding Machines Catalog

SAFETY ON MILLING MACHINES
CHIP SHIELDS FOR BRIDGEPORT MILLING MACHINES (CONTINUED)
REAR SHIELD
A rear shield is also available to protect the back area of the milling
machine. This shield is easy to install and mounts directly onto the
machine frame with a setscrew to hold it in place.
6"
9"
6"
3¼"
4"
18" Rear shield only (front shield not shown).
Ordering Information
PART NO.
DESCRIPTION
KYL-020 7¼" H x 18" W Rear Shield With Two 45° Bends
KYL-065 7¼" x 18" Rear Replacement Shield Only
BRIDGEPORT VERTICAL MILLING MACHINE CONTROLS
This control is designed for Bridgeport vertical milling machines that have a table motor. Each milling machine control is housed in a NEMA 12
enclosure that includes a disconnect switch, reversing magnetic main drive motor starter, a control relay for the table motor, and a 100 VA transformer
that is generically numbered and wired to terminals. A remote station provides the operator controls consisting of a self-latching red emergency-stop
palm button, an illuminated green table motor reset push button, and a main motor reverse/off/forward selector switch. These Bridgeport vertical
milling machine controls are available for machines with 230 or 460 V AC and 1 to 3 HP.
17"
Ordering Information
PART NO.
DESCRIPTION
BVM-230-1 For 1 HP, 230-V AC Machines
BVM-230-15 For 1.5 HP, 230-V AC Machines
BVM-230-2 For 2 HP, 230-V AC Machines
BVM-230-3 For 3 HP, 230-V AC Machines
BVM-460-1 For 1 HP, 460-V AC Machines
BVM-460-15 For 1.5 HP, 460-V AC Machines
BVM-460-2 For 2 HP, 460-V AC Machines
BVM-460-3 For 3 HP, 460-V AC Machines
3½"
10"
8¼"
SAFETY SHIELDS | 41