SMG Catalogue Issue 45 26.01.20
The current Marine Electronics catalogue from SMG
The current Marine Electronics catalogue from SMG
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
CHARGERS
Alfacharge Wireless Chargers
011-AL1 AL1 12/24VDC Wireless Phone Charger £57.44
011-AL3 AL3 12/24VDC Wireless Phone Charger - Surface Mount £64.20
011-AL4 AL4 Mains powered Wireless Phone Charger - Surface mount £78.00
AL1 Integrated
Phone Charger
Wireless charging is increasingly becoming the preferred method of
maintaining baery power in mobile devices, with most of the latest designs
from the major manufacturers including wireless charging as standard.
The AL1 series module is typically housed in an apparatus that enables
mobile devices to be retained in posion on the vehicle during charging.
The AL3 wireless charger is typically installed into table tops or other flat
surfaces.
The AL4 wireless charger is typically installed into table tops or other flat
surfaces and powered from the mains.
● Accepts both 12Vdc & 24Vdc (AL1/AL3)
● Approved to EN50498 and ISO7637-2.
E marked (Reg10) and CE marked.
● Phone communicates every millisecond
to establish correct charge.
● 2A internal fuse to protect against
catastrophic failure
● Foreign object detecon & acvaon
● Convenient wide input of 9-32Vdc in
one standard casing
● LED to confirm correct operaon.
AL4 Wireless
Phone Charger -
Table Mount
AL3 Wireless
Phone Charger -
Surface Mount
PowerTector Solid State Baery Guard
Input
Voltage
Output
Voltage
Output
Current
Continuous
SSP
Inc VAT
PowerTector - Low Voltage Disconnect IP65
011-PT10 9 VDC - 32 VDC 10 Amps £24.00
011-PT20 9 VDC - 32 VDC 20 Amps £34.80
011-PT40 9 VDC - 32 VDC 40 Amps £67.20
011-PT60 9 VDC - 32 VDC 60 Amps £84.91
011-PT100 9 VDC - 32 VDC 100 Amps £168.00
011-PT200 9 VDC - 32 VDC 200 Amps £204.00
Selected models also available as IP 65 RU (Ruggedised) - POA
The PowerTector Baery Guard is a solid state device
that will monitor the source voltage and disconnect the
baery if the voltage falls below a pre-determined level.
The PowerTector unit can be set to disconnect equipment
at a lower voltage that will sll protect the baery from
total discharge, while allowing for maximum baery usage.
● Can be operated via the ignion or a manual switch
● Remote Audible alarm and/or Visual indicator can be
installed
● Programmable terminal disconnect voltage
● LED indicates operaonal status.
● Models from 40A upwards are mounted in a rugged die
cast aluminium casing with glass filled polycarbonate.
● All units are protected to IP65 therefore fully waterproof
● Suitable for both 12VDC and 24VDC electrical systems
PowerTector PT200
PowerVerter Pro 12/24 - 5V USB Chargers
011-PVPRO-S Single Output - 2.1A £19.15
011-PVPRO-D Double Output - 3.0A (1.5A per socket) £23.66
011-PVPRO-SFF Single Output - 2.1A - Front Fitting £20.52
011-PVPRO-DFF Double Output - 3.0A - Front Fitting £25.01
The PowerVerter USB range includes a standard design that can
be used in regular as well as slim-line installaons. Aesthecally the
design has been improved with a dark grey body and contrasng light
grey ring as well as an aracve and more obvious LED indicator. This
helps to draw aenon to the unit and encourages use. Part numbers
are: PVPro-S for a single output and PVPro-D for a double output.
The front fing system has also been improved with a round bezel
with tamperproof covering ring to hide the screws, yet sll allow the
unit to be replaced quickly and easily should this be required.
Electronically, the design now includes automac short circuit
detecon, so in the event of tampering or compromise, the unit will
automacally shut down, then re-start again once the fault has been
removed.
● 12Vdc and 24Vdc systems
● Up to 2.1A output (single),
3.0A (double) max 1.5A per socket
● Apple and Android compable
● LED output indicator
● CE and E Marked
Front fitting versions
for when rear access
is limited
Single Output
Dual Output
PowerVerter PV65R 12/24VDC USB Chargers with IP65
011-PV65R-S PV65R-S Single Output - 2.1A - IP65 £25.08
011-PV65R-D PV65R-D Double Output - 3.0A (1.5A each) - IP65 £33.55
011-PV65R-SFF PV65R-SFF Single Output 2.1A Front Fit - IP65 £26.45
011-PV65R-DFF PV65R-DFF Double Output 3.0A Front Fit - IP65 £34.92
011-USB-POD USB-POD Universal mounting pod for USB Chargers £5.52
011-USB-TPOD USB-TPOD Table mounting pod for USB Chargers £6.91
011-PV-USB-H1 PV-USB-H1 Standard 1.2m wiring with inline 2A fuse £8.35
The PV65R range of USB chargers offers all the
performance benefits of the PVPro range with addional
protecon provided to the electronic circuit of the
unit. A durable polyurethane compound encompasses
the electronic components offering comprehensive
protecon against dust and liquid ingress to IP65.
● 12Vdc and 24Vdc systems
● Up to 2.1A output (single),
3.0A (double) max 1.5A per socket
● Apple and Android compable
● LED output indicator
● Meets EN50498, ISO7637-2, EN61373 and
EN50155 and is both CE and E marked
● Made from V0 rated (self-exnguishing) high impact
polycarbonate
Single Output
Dual Output
ALFATRONIX
All prices SRP inc VAT. For trade prices and stock availability visit www.smgeurope.com
135