FSB Full Hardware Collection

Fittings for entrance doors
Angular welded ht door pull
Aluminium
Stainless steel
Bronze
66 6527
Angular grip cross-section
Rectangular tube 35 × 35 × 3 mm
Bracket centres (A) 350 mm to 2,100 mm
– Works-welded
– Made to order
– Desired bracket combinations (see
below) are expressed by combining
numbers, e.g. 66 6527 4545
– The bracket spacing (A) is measured
from the centre of the screw hole of one
bracket to the centre of the screw hole
of the other bracket; the overall length
of the door pull is determined by adding
the dimensions 2 × 20 mm (drill hole
centres including material thickness).
When using angular welded ht door pulls,
structural requirements and conditions
on site must be considered. These handles
are no substitute for gymnastic bars and
must not be used as safety barriers at
hazardous building openings. If in doubt
please consult the architect or structural
engineer in charge. Fixing system details
can be found on page 691 ff.
45 . . 45 . . 46 . . right 46 . . right 56 . . left 56 . . left
8a
35 35 40 40 40 40
. . 45 . . 45 .. 46 right .. 46 right . . 56 left . . 56 left
fsb.de/catalogue
643