Specialty Automotive Hand Tools – SP Tools Schley Products

••••••••••AIR COOLED VW•••••••••
VW VALVE 13 MM JAM NUT
ADJUSTMENT TOOL
This tool features a window in its socket to see the position of the screwdriver blade holding the adjustment
screw as the jam nut is tightened. This allows for quicker valve adjustment times as the technician can
hold the adjustment screw exactly where he wants it. The unique handle pivots from one side to the other,
so the window is always visible. Made from heat treated steel this tool comes with a soft grip handle.
VW DISTRIBUTOR DRIVE PULLER
Designed for the removal and installation of the distributor drive in all air-cooled VW engines while the engine
is assembled. Easily change the direction of the distributor rotor by changing the drive slot direction. This handy
tool is precision ground to fit in the drive hole, thus assuring perfect alignment of the drive for easy removal
or installation. This tool has been designed for a sure grip on the drive, for use on all type I, II & III engines.
Part Number 79150
VW CLUTCH ADJUSTING WRENCH
This tool has been designed to simplify the task of adjusting clutch cables on air-cooled
VW’s having wing nuts. The tool has four gripping areas, rather than the wing nut’s
two, which provide for greater leverage and ease in turning the nut. Made of quality
steel this tool comes with a black finish.
Part Number 86250
PORSCHE & VW FLYWHEEL LOCK
This universal flywheel lock has been designed for use on all air-cooled Porsche engines (series 356, 912, 914
& all 911s through 1969) and on all air-cooled Volkswagen engines (type 1,2,3 & 4). This tool is a must when
changing a flywheel or its seal and it comes in handy when changing a clutch. Part Number 80350
Part Number 80250
Part Number 88900
END PLAY MEASURING TOOL
This tool has been designed to measure the end play movement of the VW crankshaft without the use of a
dial indicator. With the tool bolted to the end of the case using a feeler gauge measure the gap created by the
end play. The taking of this end play measurement is necessary whenever a VW engine is rebuilt to prevent
the rear main bearing from siezing up. A must for rebuilding an engine. Works on all air-cooled VW engines
••••••••••MOTORCYCLE••••••••••
HARLEY DAVIDSON FRONT FORK CAP TOOL
This special tool has been designed to R&R the front fork caps on 1984 and later big
twin Harley Davidson Motorcycles. Removing the fork cap is necessary when servicing
fork fluids. This is required at each 10,000 mile service. In most cases it eleminates the
need to undo electric connectors and remove the flairing on FLH, FLHT, FLTR and FLHX
models, this results in a savings of over 30 minutes.
Part Number 67250
12 & 6 POINT 2 1/8" OFFSET OXYGEN SENSOR WRENCH
This unique wrench works on 2007 and later Harley Davidson Motorcycles. Starting in 2007 these motorcycles
have an oxygen sensor in a confined area of the exhaust system. Using the 2 1/8" offset oxygen sensor, removal and
replacement is simple without removal of the exhaust system. PATENT PENDING Part Number 93750A
MOTORCYCLE AXLE WRENCH
Used with HONDA•KAWASAKI•SUZUKI•YAMAHA
Part This unique tool is used to install and remove front wheel axles and swing arm pivot shafts. It is a
Number double sided wrench which has both a 19 mm and 24 mm hex. There is also a 3/8" square drive
63850 hole in the handle to provide easy torque adjustments. Made from heat treated steel.
29 SP TOOLS / SCHLEY PRODUCTS INC.