Megaplex-4100

Quick Start Guide Installation and Operation Manual
Configuration Instructions
Turn On
Caution
When an external feed and ring voltage source is connected to the PS modules
installed in the Megaplex-4100, always turn that source on only after the PS
module(s) have been turned on.
Note
1. Set the POWER switch(es) on the rear panel(s) of the PS module(s) to ON,
and monitor the power-up initialization process.
2. After the power-up initialization ends, all the POWER indicators must light,
the ON LINE indicator of the active CL module lights in green and that of the
other CL module flashes slowly in green.
Preparations for Configuration
1. Connect a terminal to the CONTROL DCE connector of the active CL module
(use a straight cable).
You can also connect the terminal in parallel to the CONTROL DCE connectors of
both CL modules installed in the Megaplex-4100, using a Y-cable.
You may use any standard ASCII terminal (dumb terminal or personal
computer emulating an ASCII terminal) equipped with an RS-232
communication interface. Make sure to use VT-100 terminal emulation.
2. Configure the terminal for communication with the Megaplex-4100.
If the Megaplex-4100 default configuration has not yet been changed,
configure the terminal for 115.2 kbps, one start bit, eight data bits, no parity,
and one stop bit. Select the full-duplex mode, echo off, and disable any type
of flow control.
3. Press once to obtain the log-in screen.
If the power-up initialization has not yet been completed, you may see the
decompression and initialization process. In this case, wait for the prompt: In
order to start working - press the ENTER button for few times before
pressing .
4. Log in as administrator.
If the Megaplex-4100 default user name and password have not yet been
changed, log in as administrator using su as the user name and 1234 for
password.
5. If your password is accepted, you will see the Megaplex-4100 main menu.
2 Megaplex-4100 Ver. 2.0