Megaplex-4100

Installation and Operation Manual Chapter 6 Troubleshooting and Diagnostics
Table 6-27. Traps List
No. Trap Attached Parameters Interpretation
1 rfc3418.coldStart
::= { snmpTraps 1 }
OID: 1.3.6.1.6.3.1.1.5.1
2 rfc3418.warmStart
::= { snmpTraps 2 }
OID: 1.3.6.1.6.3.1.1.5.2
3 rfc2863.linkUp
::= { snmpTraps 4 }
OID: 1.3.6.1.6.3.1.1.5.4
4 rfc2863.linkDown
::= { snmpTraps 3 }
OID: 1.3.6.1.6.3.1.1.5.3
5 rfc3418.authenticationFailure
::= { snmpTraps 5 }
OID: 1.3.6.1.6.3.1.1.5.5
6 rad.tftpStatusChangeTrap
OID: 1.3.6.1.4.1.164.6.1.0.1
General Traps
3418.sysName,
3418.sysLocation
3418.sysName,
3418.sysLocation
ifIndex, ifAdminStatus,
ifOperStatus, 2863.ifDescr
2863.ifAlias, 3418.sysName,
3418.sysLocation,
openViewSeverity
ifIndex, ifAdminStatus,
ifOperStatus, 2863.ifDescr,
2863.ifAlias, 3418.sysName,
3418.sysLocation,
openViewSeverity
3418.sysName,
3418.sysLocation
radGen Traps
Reports that the Megaplex-4100 has
been powered up, and successfully
completed the cold-start process.
In response, a network management
station should perform all the
operations necessary to open the
Megaplex-4100 element manager
application
Reports that the Megaplex-4100 has
been restarted (for example, by
resetting the CL modules), and
successfully completed the warm-start
process.
In response, a network management
station should perform all the
operations necessary to open the
Megaplex-4100 element manager
application
Reports that the status of the
corresponding link (ifOperStatus) has
changed from down to any other value
except notPresent.
For any value other than normal, see
description of ifOperStatus in the
following Note
Reports that the status of the
corresponding link (ifOperStatus) has
changed to down from any other value
except notPresent.
For any value other than normal, see
description of ifOperStatus in the
following Note
Reports an SNMP authentication
failure (this is usually the result of an
attempt by a manager using an
unauthorized community to access
Megaplex-4100)
tftpStatus Reports a change in the status of the
TFTP protocol (used by the RADView
map application SWDL function)
Megaplex-4100 Ver. 2.0 Handling Alarms and Traps 6-133