Megaplex-4100

Chapter 6 Troubleshooting and Diagnostics Installation and Operation Manual
Code Message Type
2026 TFTP PROCESS
COMPLETED
Default
Severity
SL(CL) Event TFTP process completed
2027 TFTP PROCESS ABORTED SL(CL) Event TFTP process aborted
Interpretation
2028 CL OVERHEATED SL(CL) Major The corresponding CL module reports excessive internal
temperature.
This may occur because the cooling vents have been
obstructed, or because of a failure of the internal cooling fan:
in this case, replace immediately the module
2029 SFP NOT EXIST SL Major The corresponding SFP is not inserted.
If the corresponding socket is occupied by an SFP, first try to
remove it, and then reinsert the SFP
2030
to
2059
Reserved for future use N/A N/A N/A
I/O Module Ethernet Port Alarms (M8E1/M8T1/M8SL/OP-108C/OP-106C)
2060 LAN NOT CONNECTED SL:CH Major No signal on Ethernet port (this alarm will not appear when
the user disables the corresponding LAN port)
2061 LCP FAIL E1 1 SL: BND Major
2062 LCP FAIL E1 2 SL: BND Major
2063 LCP FAIL E1 3 SL: BND Major
2064 LCP FAIL E1 4 SL: BND Major
2065 LCP FAIL E1 5 SL: BND Major
2066 LCP FAIL E1 6 SL: BND Major
2067 LCP FAIL E1 7 SL: BND Major
2068 LCP FAIL E1 8 SL: BND Major
PPP LCP protocol failure on specified E1 port of an MLPPP
bundle
2069 BCP FAIL SL:BND Major PPP BCP protocol failure for the MLPPP bundle
2070 PHYSICAL LOOP DETECTED SL:CH Major Physical loopback detected on one of the E1 ports included in
an MLPPP bundle
2071 OAM REMOTE FAILURE SL:BNDETH Major Remote failure occured. The failure is discovered by OAM
message process. This alarm is relevant for both bundles and
Ethernet ports
2072 PORT DOWN DUE TO FP SL:CH Major Port operation status changed to Down by the fault
propagation mechanism
1104
to
1200
Reserved for future use N/A N/A N/A
6-130 Handling Alarms and Traps Megaplex-4100 Ver. 2.0