CTC Software Maintenance - Invensys Rail

Course Details
This is a theoretical and a practical based course that provides participants with the skills to modify,
commission, fault find and maintain a CTC Centre installations. The CTC Software Maintenance course is
conducted on the customer’s installation (or in our training room) and is presented over 5 days with a
maximum of 6 participants. Theoretical training uses of a set of visual projections to review the CTC
Centre Software configuration. This is supported by structured training exercises where participants
reference the CTC Centre Software Manual and study examples of data entry. Practical training consists
of designing a station layout, creating a geographic database and assigning alarms for the operator.
We give each participant a copy of the CTC Centre Software manual and a training manual. We
continuously assess participant’s competency during the training and issue a Certificate of Competency
to participants demonstrating competency.
Location Client's or Invensys Rail' Training Facility
Duration 5 days
Format Full time work release
Requirements Access for fully equipped training facility
Normal presentation support
Access to installed equipment
Training Pre-Requisites
Participants should have
� an understanding of train control;
� competency with PCs;
� Railway authority to enter sites and access equipment under instruction.
Special Points
� Please refer to our web site (http://www.invensysrail.com) or our Competency Based Training
Catalogue for details of all the courses we run. Contact our Technology & Training department
on +61 3 9233 8840 or e-mail training.asiapacific@invensysrail.com to discuss any training
requirement.
CTC Software Maintenance Issue 5.0 Page 2 of 2
W:\TandT\Training\Courses\CTC\Software\TTDOCCS.docx