REPAIR MANUAL - Euromachines

Operation
total stroke = 940 mm
Arm
max. weight = 800 kg
Implement
-- Program the panel in multipurpose 10.
-- To couple an implement:
� when the arm is lowered, the distributor (307)
is open, thus:
� Lifting of the arm with the control valves (48)
SECTION 88 - ACCESSORIES - CHAPTER 1 19
and (49) operated by the switches B1 and B2
� The extension cylinder is powered by the
control valves (32) and (33) operated by the
switch (64).
� The sloping of the plate can be obtained by
the control valves (30), (31) and (45) oper-
ated by the switch (63).
NOTE: when the arm is not fully lowered, the control
valve (307) closes the circuit preventing its exten-
sion.
The arm extension can be used at any height. To this
purpose:
- put the arm fully down,
- tighten the screws (a) to lock the part (b), thecon-
trol valve (307) is pressed.
TELESCOPING ARM
-- When the implement is definitely coupled, re-
tract the arm fully, put the implement vertical
and lift it, then:
� Lifting of the arm with the control valves (48)
and (49) operated by the switches B1 and B2
� The outputs H3 and H4 are powered by the
control valves (30) (31) and (25) operated by
the switches (A1) and (A2).
� The outputs H1 and H2 are powered by the
control valves (30 ) (31) and (295) operated
by the switches (C1) and (C2).
� The control valves (32) and (33) operated by
the switch (64) cannot power the extension
cylinder anymore.
� The sloping of the plate can be obtained by
the control valves (30), (25) and (45) oper-
ated by the switch (63).
NOTE: other multipurpose functions can be used de-
pending on the connected implements (see table).
For the pre -cutter, use the multipurpose 9.
SP Shaking circuit supply
SR Shaking circuit return
604 82 321 00 -02 - 2005