instruction manual manual de instrucciones - Avanti Products

More documents

Recommendations

Info

under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and or grounding should be directed toward a certified electrician or an authorized Avanti Products service center. ? After plugging the appliance into a wall outlet, allow the unit to cool down for 2-3 hours before placing any contents in the Beer Dispenser compartment. � Electrical Connection �Warning� Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is damaged, have it replaced by an authorized Avanti Products service center. This unit should be properly grounded for your safety. The power cord of this unit is equipped with a three-prong plug which mates with standard three prong wall outlets to minimize the possibility of electrical shock. Do not under any circumstances cut or remove the third ground prong from the power cord supplied. For personal safety, this appliance must be properly grounded. This unit requires a standard 115/120 Volt AC ~/60Hz electrical outlet with three-prong ground. Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded. When a standard 2-prong wall outlet is encountered, it is your responsibility and obligation to have it replaced with a properly grounded 3-prong wall outlet. The cord should be secured behind the unit and not left exposed or dangling to prevent accidental injury. The unit should always be plugged into its own individual electrical outlet which has a voltage rating that matches the rating label on the appliance. This provides the best performance and also prevent overloading house wiring circuits that could cause a fire hazard from overheated. Never unplug the unit by pulling the power cord. Always grip the plug firmly and pull straight out from the receptacle. Repair or replace immediately all power cords that have become frayed or otherwise damaged. Do not use a cord that shows cracks or abrasion damage along its length or at either end. When moving the unit, be careful not to damage the power cord. � Extension Cord Because of potential safety hazards under certain conditions, it is strongly recommended that you do not use an extension cord with this unit. However, if you must use an extension cord it is absolutely necessary that it be a UL/CUL-Listed, 3-wire grounding type appliance extension cord having a grounding type plug and outlet and that the electrical rating of the cord be 115 volts and at least 10 amperes. � Reversing the Door Swing of Your Appliance This appliance has the capability of the door opening from either the left or right side. The unit is delivered to you with the door opening from the left side. Should you desire to reverse the opening direction, please call service for reversal instructions. 10
� Installation Instructions for Beer Dispenser WARNING CO2 GAS CAN BE DANGEROUS WARNING: CO2 cylinders contain high-pressure compressed gas which can be hazardous if not handled properly. Make sure you READ and UNDERSTAND the following procedures for CO2 cylinders BEFORE INSTALLATION. 1. ALWAYS connect the CO2 cylinder to a regulator. Failure to do so could result in explosion with possible death or injury when the cylinder valve is opened. 2. NEVER connect the CO2 cylinder directly to the product container. 3. ALWAYS follow correct procedures when cylinders are changed. 4. ALWAYS secure the cylinder in an upright position. 5. NEVER drop or throw a CO2 cylinder. 6. ALWAYS keep a CO2 cylinder away from heat. Store extra cylinders in a cool place (preferably 70°F). Securely fasten with a chain in an upright position when storing. 7. ALWAYS ventilate and leave the area immediately if CO2 leakage has occurred. 8. ALWAYS check the D.O.T. test date on the cylinder neck before installation. If over five (5) years, do not use, return cylinder to gas supplier. 9. NEVER connect a product container unless there are two (2) safety’s in the pressure system: a. One at or on the CO2 regulator b. One at or on the product coupler or in the pressure gas line. Beer Keg Installation Sketch 11
Page 1 and 2: Model Number / No. de Modelo: BD600
Page 3 and 4: IMPORTANT SAFEGUIDES Before the app
Page 6 and 7: Read this guide carefully. It is in
Page 8 and 9: PARTS AND FEATURES 1. Beer Tower 2.
Page 12 and 13: Castors with Lock Installation Sket
Page 14 and 15: Installation of CO2 Air Line Hose t
Page 16 and 17: � Converting Your Beer Dispenser
Page 18 and 19: FLAT BEER Foamy head disappears qui
Page 20 and 21: 3) ? Rubber hose will absorb and re
Page 22 and 23: 11) ? Not enough pressure. ? No pre
Page 24 and 25: SERVICE FOR YOUR BEER DISPENSER We
Page 26 and 27: WIRING DIAGRAM 26
Page 28 and 29: (estufa, calentador, radiador, etc.
Page 30 and 31: ? Agarre el soporte del barril por
Page 32 and 33: servicio posventa de su localidad o
Page 34 and 35: ? Chorro inapropiado del Dispensado
Page 36: ? No hay presión o esta no es sufi

instruction manual manual de instrucciones - Avanti Products

Create successful ePaper yourself

Delete template?

Save as template?