RAx Series 600-5000 - Beko
RAx Series 600-5000 - Beko
RAx Series 600-5000 - Beko
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Technical description<br />
11.14 Compressor crankcase heater<br />
During a longer downtime, the oil can intermix with the refrigerant. Therefore, "hydraulic shocks" may occur during the<br />
start-up of the compressor.<br />
To prevent this, a heating resistor was installed in the housing of the compressor which maintains a corresponding oil<br />
temperature when the control panel is switched on and the compressor is idle.<br />
Note!<br />
The heating resistor needs to be switched on at least two hours prior to the start-up of the refrigerant<br />
compressor.<br />
11.15 DMC 24 electronics (control unit compressed-air dryer)<br />
PQS0046<br />
DISPLAY<br />
28 DRYPOINT® RAX <strong>600</strong>-<strong>5000</strong> NA<br />
ESC<br />
LED BUTTON<br />
log<br />
info<br />
reset<br />
Compressor ON - green ON<br />
Drain ON – green OFF<br />
Fan 1 st stage ON – green Increase<br />
Fan 2 nd stage ON – green Decrease<br />
Service warning – orange log Log<br />
Alarm – red info Info menu<br />
Remote control active ESC<br />
Temperature in °C<br />
Temperature in °F log<br />
Pressure in bar(g)<br />
Pressure in psi(g)<br />
info<br />
set<br />
Test button condensate drain /<br />
ESC<br />
set Instrument setting menu<br />
reset<br />
Reset alarm and/or service<br />
The DMC24 controls all operations, alarms and instrument settings of the dryer. The display and the LEDs indicate all<br />
operating conditions.<br />
The LED shows that the compressor is ON.<br />
Operation of the fans is indicated by the and LEDs.<br />
During normal operation, the display shows the dew point temperature.<br />
11.15.1 Switching the dryer on<br />
When the unit is switched on, the display shows .<br />
The condensate drain test is always possible via the ESC button.<br />
• Press the button for at least two seconds to start the dryer: If the compressor was out of operation for a<br />
sufficient period of time, it will start immediately. If this is not the case, the display shows the countdown of the<br />
seconds until the compressor restarts and the LED flashes (max. delay five minutes).