driver's ed guide - Castle Creations
driver's ed guide - Castle Creations
driver's ed guide - Castle Creations
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
HIGH POWER<br />
BRUSHED MOTOR<br />
WIRING DIAGRAM<br />
Steering<br />
Servo<br />
Steering<br />
Servo<br />
in CH1<br />
Receiver<br />
<strong>Castle</strong> ESC<br />
in CH2<br />
Use a high quality<br />
connector only<br />
(not includ<strong>ed</strong>)<br />
Connect to<br />
throttle<br />
channel<br />
Battery<br />
Pack<br />
Battery (+)<br />
to<br />
Motor (+) Motor<br />
Tab<br />
(+)<br />
CASTLE ESC<br />
Brush<strong>ed</strong><br />
Motor<br />
Figure 3: High Power Brush<strong>ed</strong> Motor Setup<br />
Motor<br />
Tab<br />
(-)<br />
All ESC<br />
motor wires<br />
to Motor (-)<br />
On/Off<br />
Switch<br />
below) you may ne<strong>ed</strong> to swap the two motor<br />
wires to get the wheels to spin in the<br />
right direction.<br />
High Power Brush<strong>ed</strong> Motor Mode:<br />
(See Figure 3: High Power Brush<strong>ed</strong> Motor<br />
Setup) Connect all three of the ESC motor<br />
wires to the negative (-) side of the motor.<br />
You can either use a “Y” harness from the<br />
ESC battery input positive wire to connect<br />
to both the battery and the positive side<br />
of the motor, or use a single wire from the<br />
positive ESC input to the positive battery<br />
pole and then continue to the positive (+)<br />
side of the motor.<br />
11
Change language