driver's ed guide - Castle Creations

More documents

Recommendations

Info

32 A MUST USE setting for 3 cell (11.1v) Lithium Polymer packs. You will irreversibly damage your packs using a lower cutoff voltage! Setting 6 : 12v Cuts off/limits acceleration when the pack gets down to 12 volts. A MUST USE setting for 4 cell (14.8v) Lithium Polymer packs. You will irreversibly damage your packs using a lower cutoff voltage! Use of a 4 cell LiPo pack is covered under warranty ONLY on Monster Max ESCs. 8. Motor Timing Advancing the timing on an electric motor can have varying effects. Lowering the timing advance will reduce the amp draw, increase runtime, reduce motor/battery temperature, and
may slightly reduce top speed and punch. Raising the timing advance will increase amp draw, decrease runtime, increase motor/battery temperature, and may slightly increase top speed and punch. If you are after maximum top speed, it’s better to “gear up” to get it rather than advance the timing too far. For brushed motors, always keep this setting on NORMAL and use the end bell of the motor to “tweak” it to max RPM per the motor’s instructions. Setting 1 : Lowest A maximum efficiency setting giving long runtimes and cooler motor temps. Very useful with high Kv (low turn) motors to increase motor life and reduce motor/battery temperatures. 33
Page 1 and 2: driver ’ s ed guide Instruction m
Page 3 and 4: QUICK START GUIDE 1. Solder a high
Page 5 and 6: o 3. Reverse Amount ...............
Page 7 and 8: that you can find. The better the b
Page 9 and 10: three wires from the ESC to the mot
Page 11 and 12: HIGH POWER BRUSHED MOTOR WIRING DIA
Page 13 and 14: ESC SETUP ESC/Radio Calibration Ind
Page 15 and 16: throttle on the transmitter. If all
Page 17 and 18: ESC. If the motor is spinning in th
Page 19 and 20: from our website. Connect the large
Page 21 and 22: STEP 3 : The programming sequence i
Page 23 and 24: Setting 3 : Forward/Brake/Reverse R
Page 25 and 26: Setting 4 : 100% Power Allows 100%
Page 27 and 28: Setting 4 : Lowest Very light accel
Page 29 and 30: throttle trigger for finer control.
Page 31: Lipo pack between the initializatio
Page 35 and 36: Setting 1 : Brushless (Default) (Se
Page 37 and 38: TROUBLESHOOTING If you’re still h
Page 39 and 40: difficulty providing the power your
Page 41 and 42: Castle Creations, Inc. 540 North Ro
Page 43 and 44: 6. Throttle Dead Band Setting 1 : L

driver's ed guide - Castle Creations

Create successful ePaper yourself

Delete template?

Save as template?