Das Plasma-Schneidsystem TransCut 300 ... - Axson

More documents

Recommendations

Info

The plasma cutting power source � Suitable for building sites thanks to its robust design and IP 23 protection � Generator-compatible (required generator power 8 kVA) and suitable for use with long power cables (min. 2.5 mm²) � Optimised for single-phase grid (sinusoidal current input) � Stable arc thanks to modern inverter technology with Resonant Intelligence � High operational reliability thanks to overtemperature protection � Easy to use The TransCut 300 plasma cutting system - Plasma cutting with liquid cutting medium © Fronius 02/2006
The plasma cutting power source in detail Liquid supply � Integral tank for liquid working medium "TransCut Liquid" � A pump in the cutting device feeds the cutting medium to the torch and builds up the required operating pressure � Fill level sensor for cutting medium � Designed to be easy to carry, the cutting medium cannot escape � "TransCut Liquid" is delivered in practical cartridges The TransCut 300 plasma cutting system - Plasma cutting with liquid cutting medium © Fronius 02/2006
Page 1 and 2: The TransCut 300 plasma cutting sys
Page 3 and 4: "TransCut"- comparison with standar
Page 5 and 6: The basics The principle of plasma
Page 7 and 8: The basics The four elemental state
Page 9 and 10: The TransCut 300 functional princip
Page 11: The plasma cutting torch in detail
Page 15 and 16: The plasma cutting power source in
Page 17 and 18: TransCut vs. conventional devices L
Page 19 and 20: Cutting speed Max. cutting speed [c
Page 21 and 22: Functional accessories - guide set
Page 23 and 24: TransCut 300 - summary � Robust a

Das Plasma-Schneidsystem TransCut 300 ... - Axson

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?