Das Plasma-Schneidsystem TransCut 300 ... - Axson

More documents

Recommendations

Info

Cutting surfaces compared � The liquid working medium contains no nitrogen. This prevents nitriding of the cut edges and reduces the risk of pore formation during the next welding session � Air plasma allows the cut surfaces to nitride and oxidise more heavily TransCut 300 Air plasma Material: stainless steel 1.4301 The TransCut 300 plasma cutting system - Plasma cutting with liquid cutting medium © Fronius 02/2006
Cutting speed Max. cutting speed [cm/min] Structural steel Fronius TransCut 300 Competitor A (compressed air) Competitor B (integral compressor) Competitor C (integral compressor) Sheet thickness [mm] The TransCut 300 plasma cutting system - Plasma cutting with liquid cutting medium © Fronius 02/2006
Page 1 and 2: The TransCut 300 plasma cutting sys
Page 3 and 4: "TransCut"- comparison with standar
Page 5 and 6: The basics The principle of plasma
Page 7 and 8: The basics The four elemental state
Page 9 and 10: The TransCut 300 functional princip
Page 11 and 12: The plasma cutting torch in detail
Page 13 and 14: The plasma cutting power source in
Page 15 and 16: The plasma cutting power source in
Page 17: TransCut vs. conventional devices L
Page 21 and 22: Functional accessories - guide set
Page 23 and 24: TransCut 300 - summary � Robust a

Das Plasma-Schneidsystem TransCut 300 ... - Axson

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?