View Document Here - Hanford Site

„ n'um@oy
TECHNICAL SPECIFICATION
RPP-24544 REV td
PROJECT: Final DBVS Desicin 145579-V-SP-002 REV. 2
PROJECT NO.: 145579
CLIENT: AMECE&E — Richland, WA
0
SINTERED METAL FILTER
4.1.16 Quality System for Material Specifying Additional Testing — ASME IIIIViIi
Not applicable.
4.1.17 Control of Graded Fasteners
The following are minimum requirements for high s trength graded fasteners
produced in compliance with national consensus standards (i.e., SAE, ASTM,
ASME):
• Fasteners shall exhibit grade marks and manufacturers identification symbols
(headmarks) as required in the specifications referenced in the con tract.
• When requested by the Buyer, the Subcontractor/Supplier shall provide legible
and reproducible copies of the manufacturers Certified Material Test Report
(CMTR). These CMTR's shalt repo rt the values of the actual chemical and
physical tests performed on the represented fastener lot/material heat number.
Fastener packaging and labeling shalt be traceable by lot number or other
means to the CMTR.
• Fasteners shall be inspected and documented to verify compliance with this
QA Clause. Additionally, fasteners may also be subject to destructive testing
by the Buyer to verify compliance.
4.1.18 Hanford Analytical Services Quality Assurance Requirements Document
(HASQARD) — Volumes 1 and 2
Not applicable.
4.1.19 Hanford Analytical Se rvices Quality Assurance Requirements Document
(HASQARD) — Volumes 1 and 3
Not applicable.
4.1.20 Hanford Analytical Se rvices Quality Assurance Requirements Document
(HASQARD) — Volumes 1 and 4
Not applicable.
Pa0e+1a^VNG^.Veeixaum wu-sA'b^tasia .^/somz(sduevn wamAp.gFevzax Page 45 of 52
simws
G5-767