Eternit Integral Wall System 01

More documents

Recommendations

Info

E TERNIT CLADDING PANELS Eternit Integral Wall System installation sequence A substantial part of the job can be executed from the floor slabs. Often if the rest of the construction allows it, all materials can be brought up from the interior side. At first the metal channels are installed. Window openings are created with only the metal channels, fitting into eachother. Then follows the fixing of the windscreen protecting the building against weather influences already at an early stage. At the exterior side the cladding subframe then will be installed and the cladding panels and windows. At the interior side another team can fit in the insulation material and vapour barrier ( depending on the climate in some countries installed at the exterior side) After the electrical cables and possible other items are fit into the cavity between the Channels the wall is finished with the interior panel(s). Obviously the Integral Wall can be started at any level of the building. It is not necessary to start installation from down to the top. E TERNIT CLADDING PANELS Eternit NV Kuiermansstraat 1 1880 Kapelle-op-den-Bos Belgium Phone: +32 (0)15 71 74 25 Fax: +32 (0)15 71 74 49 E-mail: export@eternit.be
E TERNIT CLADDING PANELS Eternit Integral Wall System drawing examples Please note that these drawings are not project drawings and are therefore are only shown as an indication. E TERNIT CLADDING PANELS Eternit NV Kuiermansstraat 1 1880 Kapelle-op-den-Bos Belgium Phone: +32 (0)15 71 74 25 Fax: +32 (0)15 71 74 49 E-mail: export@eternit.be
Page 1 and 2: E TERNIT CLADDING PANELS Eternit In
Page 3: E TERNIT CLADDING PANELS Eternit In

Eternit Integral Wall System 01

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?