Reciprocating Compressors for industrial refrigeration Series RC6

Refrigeration Division
Copyright
Page 2
Grasso
All Rights reserved. No part of this publication may
be copied or published by means of printing,
photocopying, microfilm or otherwise without prior
written consent of Grasso.
This restriction also applies to the corresponding
drawings and diagrams.
Legal Notice
This publication has been written in good faith.
However, Grasso cannot be held responsible,
neither for any errors occurring in this publication
nor for their consequences.
This manual must be carefully read and understood
prior to installing and servicing the compressor
(package)
General Safety
All service operations described in this
servicemanual are only to be carried out by
well-trained/qualified personnel and even then
only after this service manual has been read
carefully and is fully understood.
Personal safety
Observe all (inter)national and/or local safety
standards, measures and regulations during
reinstalling, repairing and connecting the
compressor (package).
Mechanical safety
If the compressor does not have to be removed
from its base, it is advisable to put warning labels
on vital parts of the compressor saying that the
plant is out-of-operation and must not be started
up.
If the compressor has to be opened for service,the
frigerant has to be pumped down and the electric
supply has to be cut off.
After having run the initial 100 operating hours,it is
essential (in both new and modified plants) to
replace the red running-in filter element with the
permanent filter element supplied.
On reinstalling a compressor, it should be checked
whether the direction of rotation of the compressor
has remained the same.
Reciprocating Compressors for industrial refrigeration / Series RC6
PL6-0108/v002