GALILEO/CEILING FAN GALILEO/VENTILADOR DE TECHO - Lowe's

WIRING1. [NOTE: For each wire connection below, and use one of thewire connectors (K) provided, making sure to screw wireconnector (K) on in a clockwise direction.]Connect BLACK wire from fan to BLACK wire from ceiling.Connect WHITE wire from fan to WHITE wire from ceiling.Connect all GROUND (GREEN) wires together from fan (ondownrod and mounting bracket) to BARE/GREEN wire fromceiling. (Fig. 1)Fig. 1120 V PowerFROMCEILINGFANBLACKWHITEGROUND/GREEN (BARE)WHITEGREENBLACKNote: Black wire is hot power for fan. White wire is common forfan and light kit. Green or bare wire is ground.GREENWHITEFROM FAN2. Wrap electrical tape around each individual wire connector (K)down to the wire as shown in Fig. 2.KWARNING: Make sure no bare wire or wire strands arevisible after making connections. Place green and whiteconnections on opposite side of box from the black connections.KKTurn spliced/taped wires upward and gently push wires and wireconnectors (K) into outlet box.Fig. 2IMPORTANT: Using a full range dimmer switch to control fanspeed will cause a loud humming noise from fan. To reduce therisk of fire or electrical shock, do NOT use a full range dimmerswitch to control fan speed. (Fig. 3)DimmerSwitchFor illustrative purposes only--notintended to cover all types of controlsFig. 3FINAL INSTALLATION1. Locate two canopy mounting screws (L) on underside ofmounting bracket (C) and remove screw (L) closest to the openend of the hanging bracket (C). Partially loosen the other screw(L). Lift canopy (B) to mounting bracket (C). Place rounded partof slotted hole in canopy (B) over loosened screw (L) in hangingbracket (C) and push up. Twist canopy (B) to lock. Re-insertscrew (L) that was removed, and then tighten both screws (L)securely. Slide canopy cover (S) up to canopy (B), aligningrounded part of slotted holes in canopy cover (S) withscrewheads in bottom of canopy (B). Turn canopy cover (S) tothe right (clockwise) until it stops. (Fig. 1)Fig. 1ALBS7