Sartorius YCC01-USBM2 YCO12 (USB-SBI), YCO13 ... - Windaus

More documents

Recommendations

Info

Installation§ Disconnect the balance/scale power supply:Unplug the AC adapter from the wall socket (mains).§ Connect the cable to the balance/scale and to the USBport on the computer.§ Plug in the balance/scale and switch it on.> Windows ® detects the cable connected to the USB port.The first time the cable is detected, Windows ® automticallyruns the Wizard for adding/removing hardware(see “Initial Connection” below).4
Initial ConnectionInstalling the Drivers for the USB Interface1. Place the enclosed CD in your computer's CD-ROM drive.2. Each version of Windows ® may have slightly differentprocedures for uploading the driver from the CD.All versions have a Wizard for adding and removinghardware, which guides you through the process.3. After you click on “Finish” at the end of the process,the virtual port should be ready to operate.Windows ® usually adds the virtual port in the positionfollowing your highest-numbered COM port. For example,on a PC with 4 COM ports, the virtual interface is addedas COM5 (shown in the Device Manager).5
Page 1 and 2: Installation Instructions | Install
Page 3: Intended UseThis USB interface cabl
Page 7 and 8: Plug & Play Mode with Autoprint (SB
Page 9 and 10: Installation§ Spannungsversorgung
Page 11 and 12: InstallationshinweiseInstallationsa
Page 13 and 14: ApplicationCe câble de connexion U
Page 15 and 16: Connexion initialeInstallation du p
Page 17 and 18: Mode Plug-and-Play dans Autoprint (
Page 19 and 20: Installazione§ Staccare l'alimenta
Page 21 and 22: Note per l’installazioneIstruzion
Page 23 and 24: FinalidadEste cable de conexión US
Page 25 and 26: Conexión inicialInstalar los contr
Page 27 and 28: Modo Plug & Play en Autoprint (SBI)

Sartorius YCC01-USBM2 YCO12 (USB-SBI), YCO13 ... - Windaus

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?