Instructions de montage / Mode d'emploi - Truma Gerätetechnik ...
Instructions de montage / Mode d'emploi - Truma Gerätetechnik ...
Instructions de montage / Mode d'emploi - Truma Gerätetechnik ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Installation instructions<br />
Safety instructions<br />
24<br />
This <strong>de</strong>vice contains components that can generate a<br />
spark or an arc!<br />
The installation and connection of electrical <strong>de</strong>vices must always<br />
be carried out by suitable electrical experts!<br />
Solar modules generate electricity when sunlight falls on<br />
them. The full voltage is present, even if little light is present.<br />
The idle voltage can be twice as high. Do not touch live components.<br />
Cover solar modules with a cardboard box, for example,<br />
before carrying out assembly or installation work.<br />
The <strong>de</strong>vice has been <strong>de</strong>veloped for connecting solar modules.<br />
Only suitable modules may be used, e.g. <strong>Truma</strong> SM 23.<br />
Please pay attention to the maximum voltage and power consumption<br />
values.<br />
Only use the prescribed line cross-sections and fuse<br />
strengths!<br />
Do not install or operate the <strong>de</strong>vice in wet rooms (e.g. bathrooms)<br />
or in rooms in which easily flammable gas mixtures<br />
can occur.<br />
The installation of the <strong>de</strong>vice must comply with the technical<br />
and administrative regulations of the respective country of<br />
use (e.g. EN 1648). National regulations and rules must be<br />
followed.<br />
Scope of <strong>de</strong>livery<br />
– 1 Solar Battery Charger<br />
– 1 Set of operating and installation instructions<br />
Assembly<br />
See page 3, fig. B, C<br />
The <strong>de</strong>vice must be protected from moisture and damp. The<br />
installation site must be clean, dry and well ventilated. The<br />
<strong>de</strong>vice should be installed in the vicinity of the battery. The<br />
housing can heat up to approx. 80 °C during operation.<br />
Ensure that the ventilation slits are kept free! Ina<strong>de</strong>quate<br />
ventilation can make the <strong>de</strong>vice overheat!<br />
The installation room the the <strong>de</strong>vice must have ventilation<br />
openings at the top and the si<strong>de</strong>s with a total opening size<br />
of 100 cm².<br />
If the internal temperature of the <strong>de</strong>vice increases because of<br />
lack of air circulation or an ambient temperature that is too<br />
high, the <strong>de</strong>vice may be damaged.<br />
Liquid electrolyte batteries must be installed in a separate box<br />
with ventilation leading to the outsi<strong>de</strong>. A separate box is not<br />
required for gel or AGM batteries. Pay attention to the battery<br />
manufacturer's installation instructions.<br />
Fix the <strong>de</strong>vice in place with two screws (diameter 4 mm – do<br />
not use countersunk head screws). The screw length and<br />
torque <strong>de</strong>pend on the subsurface.