Secadoras SAVE THESE INSTRUCTIONS - ManageMyLife

12
Using the dryer.
Fabric Care Labels
Below are fabric care label "symbols" that
affect the clothing you will be laundering.
Wash Labels
washt4achine U U__ U _ 8 C___
cycle Ho_malp...........tP,ess/ wrinkle resistant delicate Ge_,UemHand wash Do,,otwash Do,,otwd,,g
Front load Target Automatic
L_dLfarrierwater Categorg __ Water Temperature Temperature __ Control
Tap CoW Inlet Water Temperature Not used
4- _ 4_
LemFeraLure Cold 27°C/80°F Used
Dry Labels
Warm 40°C/10S°F Used
Hot 50°C/120°F Used
Sanitize 70°C/160°F Used
Tumble D
flrv
_'.z _ Do not dry
Heat
setting
Dry Normal Permanent Press/
wrinkle resistant
@ ® ®
High Nedium Low No heat/air
Gentle/ Do not tumble dry {used with
delicate do not wash)
fp_Ciualtions S E_ _ D
Bleach Labels
Line dry/ Drip dry Dry fiat In the shade
hang to dry
Bleach A A
sym bals Any bleach Only ...... hlodne bleach Do not bleach
(when needed) (when needed)
Care and Cleaning of the Dryer
Drger Interior and Duct: The interior of
the appliance and exhaust duct should be
cleaned once a year by qualified service
personnel.
The Exterior: Wipe or dust any spills or
washing compounds with a damp cloth.
Dryer control panel and finishes may be
damaged by some laundry pretreatment
soil and stain remover products. Apply
these products away from the dryer. The
fabric may then be washed and dried
normally. Damage to your dryer caused by
these products is not covered by your
warranty.
Do not touch the surface or the display
with sharp objects.
The Lint Filter: Clean the lint filter before
each use. Remove by pulling straight up.
Run your fingers across the filter. A waxy
buildup may form on the lint filter from
using dryer-added fabric softener sheets.
To remove this buildup, wash the lint
screen in warm, soapy water. Dry
thoroughly and replace. Do not operate
the dryer without the lint filter in place.
Vacuum the lint from the dryer lint filter if
you notice a change in dryer performance.
Stainless Steel: To clean stainless steel
surfaces, use a damp cloth with a mild,
nonabrasive cleaner suitable for stainless
steel surfaces. Remove the cleaner
residue, and then dry with a clean cloth.
Thestainlesssteelused to makethe dryerdrum
providesthe highestreliabilityavailableina GE
dryer.Ifthe dryer drum should bescratchedor
dented duringnormal use,the drum will not
rustor corrode.Thesesurfaceblemisheswill not
affectthe function or durabilityof the drum.
The Exhaust Hood: Check with a mirror
that the inside flaps of the hood move
freely when operating. Hake sure that
there is no wildlife (birds, insects, etc.)
nesting inside the duct or hood.