Secadoras SAVE THESE INSTRUCTIONS - ManageMyLife

Before you call for service...
Troubleshooting Tips
Save time and mone_j! Review the charts on the following pages,
or visit GEAppliances.com. You may not need to call for service.
PROBLEM Possible Causes What To Do
Dryer shakes or Some shaking/noise is normal. . Hove dryer to an even floor space, or adjust leveling legs
makes noise Dryer may be sitting unevenly as necessary until even.
Clothes take too long Improper or obstructed ducting * Check the Installation Instructions to make sure the
to dry dryer venting is correct.
Improper sorting
Largeloads of heavy fabrics
(like beach towels}
Controls improperly set
Lint filter is full
Blown fuses or tripped circuit
breaker
Overloading/combining loads
Hake sure ducting is clean, free of kinks and
unobstructed.
Check to see if outside wall damper operates easily.
Separate heavy items from lightweight items (generally,
a well-sorted washer loud is a well-sorted dryer load).
Large,heavy fabrics contain more moisture and take
longer to dry. Separate large, heavy fabrics into smaller
loads to speed drying time.
Hatch control settings to the load you are drying.
Clean lint filter before every load.
Replacefuses or reset circuit breakers.Since most
dryers use 2 fuses/breakers, make sure both are
operating.
Do not put more than one washer loud in the dryer at
a time.
Underloading . Ifyou are drying only one or two items,add a few items
to ensure proper tumbling.
The DRYdryness level Load consists of a mixture . When combining heavy and light fabrics in a load,
was chosen but load is of heavy and light fabrics choose MOREDRY.
still damp
Exhaust sgstem is blocked , Inspect and clean exhaust system.
Control pads not Controls accidentally put in _ PressSTART/PAUSE.
responding service mode
Controls accidentally put in _ Hold the LOCKbutton for 3 seconds to unlock the dryer.
lock mode
Controls performed an _ Resetthe in-house breaker.
incorrect operation
Dryer doesn't start Control panel is "asleep" • Thisis normal. PressPOWERto activate the control panel.
No numbers displayed
during cycle, only lights
46
Dryer is unplugged * Hake sure the dryer plug is pushed completely into
the outlet.
Fuseis blown/circuit breaker * Check the building's fuse/circuit breaker box and
is tripped replace fuse or reset breaker.NOTE:Electricdryers
usetwo fuses or breakers.
Dryer was accidentally paused * Ifthe light on the START/PAUSEbutton is flashing,
when starting Delay Start the dryer is paused. PressSTART/PAUSEtorestart
the countdown.
Drger is continuouslg
monitoring the amount of
moisture in the clothes
Thisis normal. When the dryer senses a low levelof
moisture in the load,the dryer will display the dry time
remaining.