3•2•1® gs series iii 3•2•1 series iii - Bose

SETUP
Controlling another component
With your CBL SAT, VCR, or other component turned
on, follow these steps.
1. In the Device Codes list, find the codes for the type
and brand of your component.
2. On the 3 2 1 ® remote, press and hold the
button for this component for several
seconds.
Wait until the red light at the top of the
remote turns on.
3. Enter the device code for your component.
The light turns off briefly as you press each key.
4. Make sure the light turns off completely after all
digits are entered.
If the light blinks instead of turning off, the code is
invalid. Return to step 2 and try a different code for
your component.
32
Svenska Nederlands Français Italiano Deutsch Español English
or
AUX
5. Point the 3 2 1 remote at your
component and press the On/
Off button for this source.
Use the 3 2 1 remote to turn
the component on again and to skip
forward by pressing channel up or down.
If it performs both operations, this code is
correct. Write the code numbers below:
If this code does not work, repeat steps 2-5
using a different code for your component.
AUX