Manual tehnic expresoare Saeco Armonia ESE

help prevent potential negative consequences for the
environment and human health, which could otherwise
be caused by inappropriate waste handling of this
product. For more detailed information about recycling
• 20 •
Problem Possible cause Solution
The machine does not switch
on.
The machine is not connected to the
power supply.
Connect the machine to the power supply.
The pump is very noisy. There is no water in the tank. Refi ll with water (section 4.4).
The coffee is too cold.
The milk does not froth.
It is not possible to prepare a
cappuccino.
The coffee is brewed too fast,
crema does not form.
Coffee is not brewed or
brewed in drips only.
Coffee fl ows out of the edges.
The machine ready light (5) was off
when the brew button was pressed (4).
Wait until the machine ready light turns on.
The portafi lter was not preheated
(section 5).
Preheat the portafi lter.
The cups are too cold. Preheat the cups with hot water.
The milk is not suitable: powdered milk
or low-fat milk has been used.
The Pannarello and/or steam spout
is dirty.
There is no steam left in the boiler.
There is not enough coffee in the
portafi lter.
The grind is too coarse.
of this product, please contact your local city offi ce, your
household waste disposal service or the shop where you
purchased the product.
Use only cold, whole milk.
Clean the Pannarello as described in
section 9.
Prime the circuit (section 4.5) and repeat
the procedure described in section 8.
Add coffee (section 5).
Use a different blend or a fi ner grind of
coffee (section 6).
The coffee is old or not suitable. Use a different blend (section 6).
The pod is old or not suitable. Use a different, single-dose pod.
The water tank is empty. Refi ll with water (section 4.4).
The grind is too fi ne. Use a different blend (section 6).
Coffee has been tamped or pressed in Empty the portafi lter and insert only 1-2
the portafi lter.
doses of coffee (without tamping).
There is too much coffee in the
Reduce the quantity of coffee in the
portafi lter.
portafi lter (only 1 - 2 scoops).
The hot water/steam knob (7) is open. Close the knob (7).
The machine has limescale build-up. Descale the machine (section 10).
The fi lter in the portafi lter is clogged. Clean the fi lter (section 9).
The pod is not suitable (double-dose).
Change the type of pod; use a single-dose
pod only (section 6).
The portafi lter is incorrectly inserted in
the brew unit.
Insert the portafi lter correctly (section 5).
The upper edge of the portafi lter is
dirty.
Clean the edge of the portafi lter.
The pod is inserted incorrectly.
Insert the pod correctly. Make sure it does
not hang over the edge of the portafi lter.
There is too much coffee in the
Reduce the quantity of coffee using the
portafi lter.
measuring scoop (use only 1-2 scoops).
Please contact an authorized service center for any problems not covered in the above table or when the suggested
solutions do not solve the problem.
For assistance in the U.S. or Canada, contact Saeco Customer Service at 1-800-933-7876 (U.S.) or 1-514-385-5551 (Canada).