Template BA B168xH238 - Hormann.fr
Template BA B168xH238 - Hormann.fr
Template BA B168xH238 - Hormann.fr
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
ENGLISH<br />
14<br />
Displays for Errors/Warnings and Operating Conditions<br />
If there is an error or warning, a number will appear with a rapidly flashing decimal point.<br />
14.1<br />
Display of errors and warnings<br />
Display Error/warning Possible cause Remedy<br />
Reversal limit cannot be set An obstacle was in the way when Remove the obstruction<br />
the SKS/VL reversal limit was set<br />
Partial opening height cannot be<br />
set<br />
The partial opening height is too<br />
close to the CLOSE end-of-travel<br />
position (≤ 120 mm slide travel)<br />
The partial opening height must be higher<br />
Entry not possible<br />
Not possible to give a travel<br />
command<br />
The parameter is set to 0 in<br />
menu 4 and an attempt was<br />
made to activate automatic<br />
timed closing (menu 3,<br />
parameters 1 – 9)<br />
The operator has been blocked<br />
for the control elements and a<br />
travel command was given<br />
Activate the safety device(s)<br />
Run time limitation The belt is torn Exchange the belt<br />
The operator is defective<br />
Release the operator for the control elements<br />
Exchange the operator<br />
System error Internal error Restore the factory setting (see Section 4.6), teach in<br />
the operator again or exchange, if necessary<br />
Force limit<br />
The door is sluggish or does not<br />
move smoothly<br />
Obstruction in door area<br />
Correct the door travel<br />
Static current circuit The wicket door is open Close the wicket door<br />
The magnet has been fitted the<br />
wrong way<br />
The testing result is not OK<br />
Remove the obstruction and teach in the operator<br />
again, if necessary<br />
Fit the magnet correctly (see the instructions for the<br />
wicket door contact)<br />
Exchange the wicket door contact<br />
Photocell No photocell is connected Connect a photocell or set the parameter to 0 in<br />
menu 4<br />
The light beam is interrupted Adjust the photocell<br />
The photocell is defective Exchange the photocell<br />
Closing edge safety device The light beam is interrupted Check the transmitter and receiver and exchange, if<br />
necessary, or exchange the complete closing edge<br />
safety device<br />
8k2 resistance contact strip is<br />
defective or not connected<br />
Check the 8k2 resistance contact strip or connect to<br />
the operator via the 8k2-1T decoder unit<br />
No reference point Power failure Move the door to the OPEN end-of-travel position<br />
The operator has not been<br />
taught in<br />
The operator has not been<br />
taught in yet<br />
Teach in the operator<br />
14.2<br />
Display of the operating conditions of the operator<br />
The operator is in the OPEN end-of-travel position<br />
The operator is in an intermediate position<br />
The operator is currently in motion<br />
The operator is in the CLOSE end-of-travel position<br />
The operator is in the partial opening position<br />
Impulse input <strong>fr</strong>om a radio code<br />
20 TR10A040-E RE / 06.2010
Change language