jenn-air® 36" (91.4 cm) accolade™ downdraft ventilation system ...
jenn-air® 36" (91.4 cm) accolade™ downdraft ventilation system ...
jenn-air® 36" (91.4 cm) accolade™ downdraft ventilation system ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Complete Installation<br />
1. Plug the optional remote up/down switch into the front panel<br />
of the vent box.<br />
A<br />
B<br />
A. Remote up/down switch connector<br />
B. Remote up/down switch<br />
2. Use cable tie mounting bases and cable ties to route the<br />
switch wiring to an easily accessible area near the front inside<br />
of the cabinet.<br />
3. Use 2 screws to secure the remote up/down switch housing<br />
to the cabinet.<br />
4. Connect vent <strong>system</strong> to blower. Vent <strong>system</strong> must end with a<br />
wall or roof cap. Use clamps or duct tape to seal all joints.<br />
Grounding Instructions<br />
This appliance must be grounded. In the event of an electrical<br />
short circuit, grounding reduces the risk of electric shock by<br />
providing an escape wire for the electric current. This appliance is<br />
equipped with a cord having a grounding wire with a grounding<br />
plug. The plug must be plugged into an outlet that is properly<br />
installed and grounded.<br />
WARNING: Improper grounding can result in risk of electric<br />
shock.<br />
Consult a qualified electrician if the grounding instructions are not<br />
completely understood, or if doubt exists as to whether the<br />
appliance is properly grounded.<br />
Do not use an extension cord. If the power supply cord is too<br />
short, have a qualified electrician install an outlet near the<br />
appliance.<br />
WARNING<br />
Electrical Shock Hazard<br />
Plug into a grounded 3 prong outlet.<br />
Do not remove ground prong.<br />
Do not use an adapter.<br />
Do not use an extension cord.<br />
Failure to follow these instructions can result in death,<br />
fire, or electrical shock.<br />
NOTE: The grounded 3 prong outlet shall be located below the<br />
cooktop surface and cannot be placed in a closed cabinet<br />
without any access. Route the power cord beneath the<br />
<strong>downdraft</strong> vent <strong>system</strong> and away from the heat generated by the<br />
cooktop of other appliances.<br />
1. Plug 3-prong power cord into a grounded 3-prong outlet<br />
located inside the cabinet where the <strong>downdraft</strong> vent is<br />
mounted.<br />
2. Use the remote control or the remote up/down switch to raise<br />
the vent hood. (See the “Remote Control Operation” section.)<br />
If the vent hood does not rise, check that the circuit breaker<br />
has not tripped or a household fuse blown.<br />
3. Remove packing material.<br />
4. Install filters. See “Filters” in the “Vent System Care” section.<br />
5. Install glass. See “Glass” in the “Vent System Care” section.<br />
13