Untitled - FAAC

INDEXENGLISH1. WARNINGS page.122. TECHNICAL SPECIFICATIONS page.123. LAYOUT AND COMPONENTS page.124. ELECTRIC CONNECTIONS page.124.1. Connection of photocells and safety devices page.134.2. J7 Terminal board - Power supply (fig. 2) page.144.3. J6 Terminal board - Motors and flashing lamp (fig. 2) page.144.4. J1 Terminal board - Accessories (fig. 2) page.144.5. Connector J2 - Rapid connection to Minidec, Decoder and RP page.154.6. Connector J6 - Limit-switches rapid connection (fig.2) page.154.7. Connector J3 - Encoder rapid connection (fig.2) page.155. PROGRAMMING page.165.1. BASIC PROGRAMMING page.165.2. ADVANCED PROGRAMMING page.166. START-UP page.176.1. INPUTS CHECK page.177. AUTOMATED SYSTEM TEST page.17CE DECLARATION OF CONFORMITYManufacturer:Address:FAAC S.p.A.Via Benini, 1 - 40069 - Zola Predosa- BOLOGNA - ITALYDeclares that:Control unit model 740 D powered on 230 Vac• conforms to the essential safety requirements of the following EEC directives:• 2006/95/EC Low Voltage directive.• 2004/108/EC Electromagnetic Compatibility directive.Additional information:This product underwent a test in a typical uniform configuration (all products manufactured by FAAC S.p.A.).Bologna, 28-02-2008Managing DirectorA. BassiNotes on reading the instructionRead this installation manual to the full before you begin installing the product.The symbol indicates notes that are important for the safety of persons and for the good condition of the automated system.The symbol draws your attention to the notes on the characteristics and operation of the product.11