automazione zenith - Faac

ENGLISH8. CONNECTION OF ELECTRONIC CARDIMPORTANT: Before attempting any job on the system or operator, cut out electric power and disconnect thebatteries, if installed.Observe points 10, 11, 12, 13 and14 of the GENERAL SAFETY RULES.Observing the indications in fig.2, install the raceways and make the electrical connections from the electronicappliance to the selected accessories (fig. 27).Always separate power cables from control and safety cables (push-button receiver, photocells, etc.). Toprevent any electric noise whatever, use separate sheaths.TECHNICAL SPECIFICATIONSPower supply voltage 230Vac 50 (60)HzPower supply for accessories 24VdcAccessories max. load 200 mAAmbient temperature-20°/+55°CFuses transf./motor primarywinding / accessoriesQuick-fit connector for receivers cardsFunction logicsAutomatic/SemiautomaticTerminal board connections Open/Stop/Safety devices/Fail-safe/FlashlightCourtesy light timer 2 minCARD COMPONENTS (fig. 26)F1Fuse for transf. primary winding, 1AF2 Motor fuse, 10A (Zenith 619/625)F2 Motor fuse, 16A (Zenith 1225/1231)F3Fuse for 0,5A accessories outputJ1 Low voltage terminal board for inputs /accessoriesJ2Rapid connector for receivers cardsJ3230V power supply input terminal boardJ4 Connector for transformer primary windingJ5Courtesy light connectorJ6Flashlight output terminal boardJ7 Connector for transformer secondary windingJ8Motor output connectorP1Open push-buttonP2Set-up push-buttonLK1Enable/disable fail-safeLK2 Varies sensitivity of reversing deviceLK1= fail-safe enabledLK2= reversing sensitivity150N (~15Kg)fail-safe disabledreversing sensitivity300N (~30Kg)Fig.2618