Notice - White and Brown

More documents

Recommendations

Info

notice_MO2630-reso 23/12/05 11:08 Page 34CLEANING AND MAINTENANCEDisconnect the power supply cord before cleaning. And if possible leave the door open to inactivatethe oven during cleaning.Exterior:The outside may be cleaned with mild soap and warm water, wipe clean with a damp cloth. Avoidthe use of harsh abrasive cleaners.Door:Wipe the door and window on both sides, the door seals and adjacent parts frequently with a dampcloth to remove any spills or spatters. Do not use abrasive cleaners.Control panel:Care should be taken when cleaning the control panel. Wipe the panel with a cloth dampenedslightly with water only. Do not scrub or use any sort of chemical cleaners. Avoid the use of excesswater.Interior walls:To clean the interior surfaces, wipe with a soft cloth and warm water for hygienic reasons. Afteruse wipe the waveguide cover in the oven with a soft damp cloth to remove any food splashed.Build up splashes may overheat and begin to smoke or catch fire.Do not remove the waveguide cover. Do not use a commercial oven cleaner, abrasive or harshcleaners and scouring pads on any part of your microwave oven. Never spray oven cleanersdirectly onto any part of your oven. Avoid using excess water. After cleaning the oven, ensure anywater is removed with a soft cloth.Turntable/ Rotating ring/Rotating axis :Wash with mild soapy water and dry thoroughly.TIP:When the microwave oven has been used for a long time, there may be some strange odours inoven, you can get rid of them as follows:1. Place several lemon slices in a cup, then heat with high power for 2-3 min.2. Place a cup of red tea in oven, then heat with high power.3. Put some orange peel into oven, then heat them with high power for 1 minute.34
notice_MO2630-reso 23/12/05 11:08 Page 35SERVICINGWarning: it is hazardous for anyone, other than a qualified service technician, to carry out any servicefor repairing operation which involves removal of any cover which gives protection againstexposure to microwave energy.Caution: MICROWAVE RADIATIONDo not become exposed to radiation from the microwave generator or other parts conductingmicrowave energy.Note:if LED displays Err0 during work ,it indicates that sensor has been short circuit and youneed replace it at the nearest repaired department.if LED displays Err1 during work, it indicates that sensor has been open circuit and youneed replace it at the nearest repaired department.35
Page 1 and 2: notice_MO2630-reso 23/12/05 11:08 P
Page 5: notice_MO2630-reso 23/12/05 11:08 P
Page 36: notice_MO2630-reso 23/12/05 11:08 P

Notice - White and Brown

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?