Maytag Mhwe301yw Use And Care Manual

TROUBLESHOOTINGIf you experience Possible Causes SolutionNoisesFirst try the solutions suggested here or visit our website at www.maytag.com/helpfor assistance and to possibly avoid a service call.Clicking or metallicnoisesGurgling or hummingWater LeaksCheck the following forproper installation:Water or suds leakingfrom door or rear ofcabinetDoor locking or unlocking.Objects caught in washerdrain system.Washer may bedraining water.Fill hoses not attached tightly.Fill hose washers.Drain hose connection.Check household plumbing for leaksor clogged sink or drain.Not using HE detergent or using toomuch HE detergent.Door opened during “Add Clothes.”Residue on door glass.The door will lock unlock and lock again. You will hear threeclicks after pushing START/PAUSE. This is normal.Empty pockets before washing. Loose items such as coinscould fall between basket and tub or may block pump.It may be necessary to call for service to remove items.It is normal to hear metal items on clothing such as metal snaps,buckles, or zippers touch against the stainless steel basket.It is normal to hear the pump making a humming sound withperiodic gurgling or surging as final amounts of water are removedduring the spin/drain cycles.Tighten fill-hose connection.Make sure all four fill hose flat washers are properly seated.Check that the drain hose is properly secured to drainpipe orlaundry tub.Water can backup out of a clogged sink or drainpipe. Check allhousehold plumbing for leaks (laundry tubs, drain pipe, waterpipes, and faucets.)Only use HE detergent. Suds from regular detergents cancause leaking from the door or rear of cabinet. Always measuredetergent and follow manufacturer’s directions based on yourload requirements.Water can drip off the inside of the door when the door isopened after the start of a cycle.Periodically clean the underside of the glass window to avoidpotential leaks.Washer not performing as expectedLoad not completelycovered in waterWasher won’t runor fill, washer stopsworkingWater level not visible on door ordoes not cover clothes.Check for proper water supply.This is normal for an HE front load washer. The washer senses loadsizes and adds the correct amount of water for optimal cleaning.Both hoses must be attached and have water flowing toinlet valve.Both hot and cold water faucets must be turned on.Check that inlet valve screens have not become clogged.Check for any kinks in inlet hoses, which can restrict water flow.16